When do you need to replace an antenna?
The mast may have broken, the motor may have stopped working, or the drive system doesn’t work. Each of these can be fixed by replacing the whole antenna assembly, but you can save money by replacing the mast if it breaks or the drive system fails.
What to do if your TV antenna is broken?
If you have an old set-top box that you’re not using, you could try connecting this to your TV via your HDMI port and TV wall point instead of plugging your antenna connection straight into your TV. If this fixes the problem, it means your antenna likely doesn’t need repairing – your TV’s antenna connector is broken.
What’s the best way to fix an aluminum antenna?
Flatten and trim your aluminum strip. Using a flat, heavy object (like a book), or even your hands, flatten your spiral strip entirely. Remove any particularly bad burrs or jagged edges from your flattened strip. Collect any shards or pieces of aluminum.
How do you remove an antenna from a car?
The trim in trunk or rear area of a number of older cars is held in with screws while most newer vehicles will use clips of some sort. Removing these screws or clips allows you to remove the plastic or carpet covering the antenna. Be careful with these connectors, as the plastic can degrade and become brittle with age.
How do you replace a broken radio antenna?
You can replace the broken car radio antenna and install a new radio antenna with these simple methods. How to replace a broken car radio antenna? You can replace a broken car radio antenna by unplugging the coaxial cable, removing the rubber grommet, removing antenna screws, remove the broken antenna and add a new one.
When to remove an antenna from a car?
If there is no antenna for your car’s radio, but there is a factory antenna hole, you should feed the antenna cable through it. The main reason to remove an antenna is that if it is broken or has stopped working. Another reason for it can be the poor working of the drive system.
Can a broken radio mast save you money?
You can save a significant amount of money if you can hear the antenna motor running when the car’s radio is turned on and off but the mast doesn’t go up and down, or if the mast is broken or bent but the motor runs.
How is the antenna held against the roof?
The antenna looks like it is held against the roof by the screw and something like a crush washer, with a rubber seal around the roof penetration (in addition to the seal around the edge of the cover). On my vehicle, I was able to determine that the screw is still tight but the antenna itself is loose and can be rotated right/left.