How do you remove ball joint from frame?

Separate the ball joint from the spindle. Unbolt the rear of the lower control arm from the frame using the 3/8-inch ratchet and socket and an open-end wrench. Then slowly lower the jack to release the spring from the pocket and the lower control arm from the frame.

How to replace a lower control arm ball joint?

Replacing a Lower Control Arm Ball Joint. Learn how to replace a lower ball joint by pressing it out of the control arm and pressing the new one back in. To watch the longer, in depth version, click the link below. Press out a Ball Joint (In-depth):

How to replace the lower ball joint on a 2000 Trooper?

These are basic instructions on how to replace your lower and upper ball joints on a 2000 Trooper. You will need a 14, 17 & 27mm socket and 14 & 17 mm wrenches. To remove my hubs I need two types of allen wrenches and c-clip pliers. You will also need a ball joint separator for the lower ball joint. 1. Jack up truck and remove the tire.

How do you remove ball joint from steering knuckle?

Unbolt the lower control arm ball joint from the steering knuckle using an open-end wrench. Separate the ball joint from the spindle. Unbolt the rear of the lower control arm from the frame using the 3/8-inch ratchet and socket and an open-end wrench.

How do you remove a ball joint from a front suspension?

Place the remover in between the lower part of the spindle and the lower control arm. Strike it hard with the hammer and the ball joint will pop out of its tapered hole in the spindle. On a strut type of front suspension, it is safe to remove the lower ball joint without supporting the arm because there is no spring tension on the arm.

How do you install a ball joint on a Ford F150?

Remove the single bolt on the ABS sensor. Remove upper ball joint nut and use hammer on the stem end or spindle arm until the ball joint pops out. Push the upper control arm down to get new ball joint in place. Install upper castle end nut. Figure 6. Remove the upper ball joint nut. Remove steering tie-rod end nut, and free from spindle.

How do you replace a ball joint on a trooper?

Remove the cotter pin from the upper ball joint and loosen the nut all the way down but to donâ€™t remove it. Leave threaded at the end of the screw. 3. Use a hammer to bang around the upper spindle until it releases the ball joint. The upper A-arm will move up so be prepared. 4.

Why do you need a ball joint Remover tool?

Ball joint installer and remover tools are useful for replacing the linkages that connect a control arm to a wheel hub. These joints are designed to stand up to impact when a vehicle travels over bumps in the road or potholes and sustain pressure as the vehicle starts or stops moving.

How do you replace ball joints?

How to Change a Ball Joint in a Car Step 1 – Lift Car Step 2 – Remove the Caliper on the Brakes Step 3 – Remove the Brake Discs Step 4 – Remove Ball Joint Nuts Step 5 – Separate Ball Joint from Hub Carrier Step 6 – Remove Ball Joint Step 7 – Grease New Ball Joint Step 8 – Add New Ball Joint In Step 9 – Take Car Down

What tools are needed to replace ball joints?

The basic tools you will need to replace a ball joint are: • The replacement all joint. • 8mm hex head wrench. • 22mm or 15/16” combination wrench. • ball joint separator tool (also called a ‘pickle fork’) • hammer. First you will want to diagnosis the problem.

What is ball joint removal tool?

What are bad ball joints?

Bad ball joints take for granted the safety of the driver and all the other people in the car. This is because of the fact that the tire will not have proper traction against the road. When this happens, the driver will lose control of his or her car. One of the parts that may be damaged the most due to bad ball joints is the tire.

Navigation