How to replace the headlight on a Mercedes Benz E320?

To remove the Xenon ballast (blue arrow), remove the three T25 Torx fasteners (red arrows). To remove the Xenon headlight module (green arrow), remove the three T20 Torx fasteners (red arrows). When removing the Xenon module, inspect the module for corrosion. If needed, replace the module as well as the headlight.

How do you change the headlight bulb on a Mercedes Benz?

Once the cap has been removed, the headlight bulb can be easily accessed. Follow the headlight bulb’s wire harness to the bulb socket. Rotate the socket counterclockwise, and pull it straight out from the housing unit. Once the socket is removed, rotate the bulb counterclockwise and remove it.

Where is the low beam bulb on a Mercedes E-class?

Open the hood, and look to the corner of the engine bay directly behind the driver’s side headlight assembly. The vacuum tube support bracket is located to the right of the SBC (Sensotronic Brake Control) system. Use a 10mm socket, extension, and ratchet to remove the two bracket bolts. Move the vacuum aside to gain access to the low beam bulb.

How to remove a parking bulb from a headlight?

To disconnect an electrical connector, press the release tab and pull the connector straight off. Turn Signal / Parking Bulb: Working at the outside top of the headlight assembly, rotate the bulb holder 45 degrees counterclockwise and remove it from the headlight.

How do you replace a Mercedes Benz headlight?

Low (Xenon) Beam Bulb: Squeeze the retaining springs and unclip them from the headlight. Pull the headlight bulb out of the socket and replace it with a new bulb. Reverse the steps for installing. Be sure that the bulb is properly seated in the socket before trying to install it into the headlight.

Are there any Mercedes E320 headlights left in stock?

Only 18 left in stock – order soon. . Only 4 left in stock – order soon. . Only 1 left in stock – order soon. . Only 14 left in stock – order soon. Depo 340-1106L-AS Replacement Driver Side Headlight Assembly (This product is an aftermarket product.

Can a Mercedes Benz headlight bulb wear out?

If you are trying to diagnose a problem with a Xenon bulb, swap parts from side to side, as it is dangerous to attempt to test the high voltage output of the Xenon bulb parts. The headlight assembly seals can wear out over time resulting in water leaks and repeat bulb failures.

What kind of headlights does a Mercedes Benz W211 use?

Mercedes-Benz W211 vehicles with optional high intensity discharge (HID) or xenon headlights utilize a special high voltage bulb and control unit for low beam headlights. Conventional halogen bulbs are used for high beams. The headlights are controlled via driver input from a headlight switch then activated by the front SAM module.

How to replace a Mercedes Benz Xenon headlight?

Mercedes Benz W169 A150 A160 A180 A170 A200 OEM Headlight Xenon Ballast Bulb Igniter Control Unit Module Replacement Mercedes Benz W176 A180 A250 A200 A45 A160 A220 OEM Xenon Headlight LED DRL D1S Bulb Control Unit Ecu Module Replacement

How to change a headlight bulb on a Mercedes Benz?

Changing a headlight bulb is easy; simply follow the instructions below to replace a faulty headlight on your Mercedes-Benz E-Class or E-Class AMG. Be aware of which bulb (s) you are replacing and that you have the correct wattage replacement bulb (s). Make sure that the car and lights are off before you begin.

What kind of headlights do Mercedes Benz use?

Click here to order! Mercedes-Benz W211 vehicles with optional high intensity discharge (HID) or xenon headlights utilize a special high voltage bulb and control unit for low beam headlights. Conventional halogen bulbs are used for high beams.

Why did my halogen light bulb break on my Mercedes E class?

Hold it with a lint-free cloth or wear disposable gloves as you’re installing the new bulb. This is because when the bulb heats up, anything on the bulb’s surface, including oil and grease from your hands, will boil and break the bulb. Figure 3. Halogen headlights on a 2009 E-Class.

How to upgrade the W210 E class headlight?

Remove the 8mm bolt on top of the headlight assembly. Remove 8 mm nut on the side of the headlight assembly. This is covered by the front bumper. Remove 10 mm bolt that holds front bumper cover to headlight. Remove bolt to lower outer side of the highlight. Disconnect the headlight wiring harness. Disconnect the turn signal bulb.

How to upgrade the headlight on a Mercedes medic?

Remove bolt to lower outer side of the highlight. Disconnect the headlight wiring harness. Disconnect the turn signal bulb. Pull out the headlight assembly. If you are having a difficult time pulling out the headlight you can remove the 10mm bolts from the fender which will loosen the fender and give you room to remove the head light assembly.

What causes a Mercedes Benz headlight to leak?

The headlight assembly seals can wear out over time resulting in water leaks and repeat bulb failures. On models with high intensity discharge (HID) or Xenon lights, the HID module is located at the bottom of the headlight. Water can enter the module electrical connector causing headlight faults.

How many horsepower does a Mercedes Benz E Class 320 CDI have?

The Mercedes Benz E Class (W211) 320 CDI has a Inline 6, Diesel engine with 3222 cm3 / 196.6 cu-in capacity. How many horsepower (hp) does a 2003 Mercedes Benz E Class (W211) 320 CDI have? The 2003 Mercedes Benz E Class (W211) 320 CDI has 204 PS / 201 bhp / 150 kW.

When did the Mercedes Benz 320 CDI come out?

For stopping power, the E Class (W211) 320 CDI braking system includes Vented Discs at the front and Discs at the rear. The E Class (W211) model is a car manufactured by Mercedes Benz, sold new from year 2003 until 2005, and available after that as a used car.

How much does a 2003 Mercedes Benz E class weigh?

The 2003 Mercedes Benz E Class (W211) 320 CDI has 204 PS / 201 bhp / 150 kW horsepower. How much does a Mercedes Benz E Class (W211) 320 CDI weighs? What is the top speed of a Mercedes Benz E Class (W211) 320 CDI? Is Mercedes Benz E Class (W211) 320 CDI All Wheel Drive (AWD)?

What happens when a Mercedes Benz goes into limp mode?

When a Mercedes-Benz goes into limp mode, it only operates in second gear and reverse only. When you put it in gear, you may also feel a bang as transmission engages. The first thing you should try is to check the transmission fluid level. The transmission has a dipstick tube but with no dipstick in it.

When to replace headlight bulb on Mercedes Benz W212?

Prevent this potential headache by replacing the bulb in your Mercedes-Benz E-Class as soon as possible. This article applies to the Mercedes-Benz E-Class w212 (2010-Present). A headlight on your Mercedes-Benz E-Class is bound to go out. Fortunately, the process of replacing the bulb is quick, easy, and painless.

Is there a replacement driver’s side headlight assembly?

Depo 340-1106L-AS Replacement Driver Side Headlight Assembly (This product is an aftermarket product. It is not created or sold by the OE car company) . Only 16 left in stock – order soon.

Are there any problems with Mercedes Benz headlights?

Mercedes Benz OEM Xenon Headlight Problems HID Ballast Bulbs Ignition Part Replacement

What kind of headlamp does Mercedes Benz CL203 use?

2008-2011 Mercedes Benz CL203 CLC160 CLC180 CLC200 CLC230 CLC320 CLC350 Adaptive Headlights Not Work Headlamp Ballast Bulb Control Unit Module CLK-Class

When did the Mercedes Benz Xenon headlight stop working?

2007-2012 Mercedes Benz W216 CL500 CL600 CL63 CL65 AMG HID Bi-Xenon Headlight Stopped Work OEM Ballast Bulb Control Unit Module Replace CLC-Class

Mercedes Benz OEM Xenon Headlight Problems HID Ballast Bulbs Ignition Part Replacement

2008-2011 Mercedes Benz CL203 CLC160 CLC180 CLC200 CLC230 CLC320 CLC350 Adaptive Headlights Not Work Headlamp Ballast Bulb Control Unit Module CLK-Class

2007-2012 Mercedes Benz W216 CL500 CL600 CL63 CL65 AMG HID Bi-Xenon Headlight Stopped Work OEM Ballast Bulb Control Unit Module Replace CLC-Class

Where is the high beam bulb on a Mercedes Benz?

The yellow arrow points to the turn signal / parking bulb electrical connector (you will not disconnect this when replacing the bulb). The blue arrow points to the high beam bulb electrical connector. The red arrow points to the front driving light bulb electrical connector (this bulb illuminates the high beam capsule).

Why are my low beams not working on my Mercedes?

When it burns out it will stop suppling power to whatever lights it wants to. Multimeter the socket, no power replace the relay/check fuses of course. Suggest junk yard new they are about 200. The headlights on my 88 260E would turn OFF when I switched from high beams to low beams. Very unsettling the first time it happened.

Why are my low beams not working on my 88 260E?

Suggest junk yard new they are about 200. The headlights on my 88 260E would turn OFF when I switched from high beams to low beams. Very unsettling the first time it happened. If I fiddled with the beam change lever the lows would come on so I knew the problem was the steering column switch. I bought a new one and all ws well again.

Where is the hid module on a Xenon headlight?

On models with high intensity discharge (HID) or Xenon lights, the HID module is located at the bottom of the headlight. Water can enter the module electrical connector causing headlight faults. If this happens to you, you will have to replace the headlight, the electrical harness and the HID module.

What kind of headlight is used for high beams?

Conventional halogen bulbs are used for high beams. The headlights are controlled via driver input from a headlight switch then activated by the front SAM module. If you are trying to diagnose and issue with a standard halogen bulb, check for power and ground to the bulb.

What should the voltage be for HID headlights?

Always handle Xenon HID headlights with care. In the case of high-intensity discharge (HID) headlights, or Xenon headlights, there’s an additional component. To get the xenon and salts to plasma state, the HID generator bumps the voltage up to 30,000 V, then stabilizes around 90 V when the bulb is in operation.

Why are my high beam headlights not working?

In the case of high-intensity discharge (HID) headlights, or Xenon headlights, there’s an additional component. To get the xenon and salts to plasma state, the HID generator bumps the voltage up to 30,000 V, then stabilizes around 90 V when the bulb is in operation. If the generator fails, the bulb won’t light.

What are the common problems with Mercedes diesels?

Here are some common problems that affect many Mercedes-Benz diesel models including E350, ML350, GL350, R350, Sprinter, R320 CDI and BlueTec models. Common problems Diesel Particulate Filter. As Mercedes DPF traps and holds soot, with time it reaches a point when it needs to be ‘emptied out’. This is done by regeneration.

Where is the level sensor on Mercedes Benz air suspension?

If you need help with troubleshooting the airmatic valve assembly watch this video. Level sensor is faulty They are located at the rear and front suspension. When they stop working the air suspension control unit may no longer be able to recognize the height of the car.

Where is the headlight bulb on a Mercedes Benz W212?

A headlight on your Mercedes-Benz E-Class is bound to go out. Fortunately, the process of replacing the bulb is quick, easy, and painless. Continue reading to learn how to replace the burned out bulb in your w212. Open the hood, and look to the corner of the engine bay directly behind the driver’s side headlight assembly.

Is the Mercedes E320 CDI 4dr diesel engine rebuilt?

Engine, knock on wood, has never been opened, Tranny rebuilt at 400,000 because I drive like a German. The only thing I would change is the TAXES on Diesel.

How to change the headlight on a W210?

Pull out the headlight assembly. If you are having a difficult time pulling out the headlight you can remove the 10mm bolts from the fender which will loosen the fender and give you room to remove the head light assembly. Headlight removed. Install new headlights in reverse order. Rember to adjust the low beam after you install the new headlights.

Can you replace the headlight assembly on a Mercedes Benz E class?

How to remove, upgrade and install new headlight assembly on your Mercedes-Benz E-Class. You can either replace the headlights with OEM Halogen units or you could upgrade with projector HID lights. Owners of W210 E-Class such as E320,E430, E55 AMG and E240 will find these instructions helpful.

What is part number for Hella W210 headlight assemblies?

Here are some part number related to W210 headlights. These are for Hella Halogen headlight assemblies. You need to know if you have HID lights or halogen bulbs on your Mercedes-Benz.

How much does it cost to replace head lights on a Mercedes Benz?

These are the halogen head light and fog light bulbs for your Mercedes Benz – start from $10.95. Please consult with your vehicle owner’s manual or the bulb chart above to select the corrected bulb type. HID replacement headlight bulbs for Mercedes Benz – start from $129.95

How to replace a light bulb in a Mercedes Benz?

Light bulb replacement guide for Mercedes-Benz cars. Look up your Model on the first column then move over to the right and click on the year or chassis type. If there is something we don’t have on this page check out Philips website here.

Navigation