What type of oil does a 2000 Honda Civic use?
The 2000 Honda Civic makes use of 5w30 on all of its engine types. Depending on what engine You have You will need between 3.5 and 3.7 quarts of oil.
How do you change the oil in a Honda Civic?
Apply a light coat of fresh engine oil to the threads of the oil drain plug to ensure it seals properly. Using the box end wrench, re-install the oil drain plug tightened to a snug fit. Figure 4. Attach a new oil drain plug gasket. Alternatively, you can use a torque wrench to verify that the plug is tightened to its correct specification.
Where is the oil filter on a Honda Civic?
Remove the jack stand, then slowly lower the car to the floor. To replace the oil filter, first locate it. On the firewall side (halfway down the engine block) is where the oil filter is located. Using the oil filter wrench, remove the old oil filter by rotating clockwise.
When does maintenance light come on on Honda Civic?
In tough driving conditions with a lot of stop-and-go traffic, the maintenance light will come on after about 6,000 miles, which indicates 15 percent of oil life remaining. Warm up the engine to the operating temperatures. This helps to suspend any engine contaminants in the old oil.
Where is the drain plug on a Honda Civic?
Locate the 17 mm hex drain plug. It will be on the driver side of the oil pan facing the rear of the car. There’s a sign pointing to it if you can’t find it. Slide the oil drain pan beneath the drain plug so that it catches the oil when you start to drain it. Use a 17 mm box-end or socket wrench to loosen the drain plug.
For most Hondas, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Honda Civic oil filter wrench. If your Civic is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Civic.
How to change the filter on a Honda Civic?
Oil & Filter Change Honda Civic (1996-2000) – 1997 Honda Civic LX 1.6L 4 Cyl. 1. Getting Started – Prepare for the repair 2. Open the Hood – How to pop the hood and prop it open 3. Find Oil Drain – Locate the oil drain plug underneath the vehicle 4. Drain Oil – Set up the workspace, drain oil and replace plug
Where is the oil drain plug on a Honda Civic?
(Related Article: How to Jack Up Your Civic – Honda-Tech.com) Remove the oil cap on top of the engine. This will help the old oil to completely drain. Underneath the car (closer to the engine than the transmission) is a 17 mm hex oil drain plug, facing the rear of the car. Place the oil pan under this plug.
In tough driving conditions with a lot of stop-and-go traffic, the maintenance light will come on after about 6,000 miles, which indicates 15 percent of oil life remaining. Warm up the engine to the operating temperatures. This helps to suspend any engine contaminants in the old oil.