Is there a Honda Civic ignition control module?
We offer a full selection of genuine Honda Civic Ignition Control Modules, engineered specifically to restore factory performance. Please narrow the Ignition Spark Control Module results by selecting the vehicle. Item has been added to your cart! This part contains hazardous material.
How do you replace the ICM on a Honda Civic?
Continue reading to test and replace the ICM in your Honda Civic. With a Phillips screwdriver, remove three mounting screws on the distributor cap. Pull off the cap from the distributor housing, and make sure not to unplug the ignition wires. With the Phillips screwdriver, remove one rotor retaining screw underneath the rotor.
Where do you replace the ignition control module?
But whatever your vehicle model, follow these steps to replace the control module in your car. Park your vehicle in a safe place and locate the ignition module. Look under the dashboard. If yours is mounted here, unplug the module wiring harness.
What happens when you flip ignition on Honda Civic?
The battery is charged as well as properly connected, the spark plugs are firing, and the fuel line is intact. However, your car still won’t start, and the engine continues to sputter when you flip the ignition.
How do you replace Ignition Control Module on Honda Civic?
Remove two Phillips screws underneath the ICM to replace it. Simply install the new ICM with the same screws. Reattach the wires connecting the ICM to the distributor housing. Reattach the inner cover and rotor. Secure the rotor with the Phillips screw. Reattach and secure the distributor cap.
When does an ignition module need to be replaced?
If the light blinks, the module is good. If the light is blank or constant, the module is bad. Before you attempt to replace the control module, you must rule out other ignition system components. The module is expensive and replacing it is a laborious process. Check the ignition coil for a spark.
Continue reading to test and replace the ICM in your Honda Civic. With a Phillips screwdriver, remove three mounting screws on the distributor cap. Pull off the cap from the distributor housing, and make sure not to unplug the ignition wires. With the Phillips screwdriver, remove one rotor retaining screw underneath the rotor.
Where is the ignition control module located in a car?
However, this electronic component is very sensitive to heat. Since many vehicle models locate their modules inside the engine compartment, it is not unusual for these components to succumb eventually. But whatever your vehicle model, follow these steps to replace the control module in your car.