What are the specs of a 1987 Mustang?
Engine Specs (302 cid V8) Cylinder compression pressure 101 PSI minimum Oil pressure 40-65 @ 2000 rpm Spark plugs ASF42C set to 0.050 Cylinder head warp limit 0.003 in 6″ or 0.06 overall Thermostat starts to open / full open up 193-200 / 221 degrees
What should the timing be on a Chevy 454?
The initial timing should be 4 degrees before top dead center (BTDC). If the mark is adjacent to a higher number BTDC, the distributor must be rotated clockwise to bring it down to 4 degrees. If the number is lower or after top dead center (ATDC), turn the distributor counterclockwise.
What should the timing be on a Chevy 350?
Set the mechanical timing of the engine. Loosen the distributor hold-down bolt. Turn the distributor and use the timing light to set the timing to the vehicle manufacturer’s specifications. Remove the vacuum advance hose at the carburetor.
What’s the timing setting on a Ford 351W?
Almost all engines have a timing setting that is before top dead center. The most common setting for the 351W is 6° before top dead center.
What should the ignition timing be on a Dodge 318?
Proper ignition timing was 5 degrees after top dead center if equipped with a manual transmission and 2.5 degrees after top dead center if equipped with an automatic transmission. Note that the distributor’s vacuum hose must the disconnected from the distributor and plugged so that idle speed is not affected.
What should the timing be on a 351 Windsor?
You sure ??? O/K then I”ll stick my head out…Say 12mm infront of tdc it should atleast be fireing..You can get some stick on stuff that shows degrees…Another way is mark on ballancer where you want max timing, then mark..Sat you want 28* total max??
How does the timing work on an outboard motor?
The timing settings on an outboard motor control the boat’s power and acceleration and are an important part of your boat’s health. Adjusting the timing on a Mercury outboard motor is relatively easy, as long as you have a timing light, dial indicator and spark plug gap tool. All owner manuals will have instructions on timing adjustments.