How much HP does a turbo kit add?
A turbocharger works with the exhaust system and can potentially give you gains of 70-150 horsepower. A supercharger is connected directly to the engine intake and could provide an extra 50-100 horsepower.
Can you put a turbo kit on a stock engine?
Turbocharging your car’s stock engine will substantially increase the engine’s horsepower potential. However, there are many upgrades you can perform on your stock engine that can be utilized when installing a turbo system in the future, allowing for maximum turbocharged horsepower potential.
Which fuels can an Otto engine run on?
The Otto Cycle engine was eventually adopted to run on Ligroin and eventually gasoline, and many gases. During WWII Otto engines were run on more than 62 different fuels, such as wood gas, coal gas, propane, hydrogen, benzene, and many more. The engine is limited to light fuels.
Do turbos increase fuel economy?
A turbocharger typically helps a car get better gas mileage because a smaller engine can be used to get the same amount of performance. Expect a turbocharged engine to be about 8% -10% more fuel efficient that the same engine that is not turbo equipped.
How long should you wait to turn off a turbo car?
Generally, I recommend that a turbocharged car be driven gently (no boost) for a couple of minutes before stopping, and then the engine be allowed to idle for at least 30 seconds to allow the turbo to spool down to minimal rpm before shutting off the engine.
Is it legal to turbo your car?
Turbochargers and Superchargers Adding a turbocharger or supercharger to your car is another popular performance modification. 1 in illegal mods), however, turbochargers and superchargers are legal as long as they don’t cause your car to fail your state’s emissions check or safety inspection.
Does diesel engine work in Otto cycle?
The Diesel cycle is a combustion process of a reciprocating internal combustion engine. This is in contrast to igniting the fuel-air mixture with a spark plug as in the Otto cycle (four-stroke/petrol) engine.
What is the difference between Diesel cycle and Otto cycle?
Otto cycle is used for petrol or spark ignition engine while diesel cycle is used for diesel or compression ignition engine. The main difference between Otto cycle and Diesel cycle is that in Otto cycle heat addition takes place at constant volume and in diesel cycle heat addition takes places at constant pressure.
How is the Otto cycle used in an engine?
The Otto cycle is a set of processes used by spark ignition internal combustion engines (2-stroke or 4-stroke cycles). These engines a) ingest a mixture of fuel and air, b) compress it, c) cause it to react, thus effectively adding heat through converting chemical energy into thermal energy,…
How is the Brayton cycle different from the Otto cycle?
All three cycles are suitable for internal combustion engines and therefore engine-driven power generation applications. Otto and Diesel cycles are operated by a piston-cylinder mechanism while the Brayton cycle drives a gas turbine. Hence, in this chapter, the Brayton cycle and its derivatives are explained in detail.
How is the Carnot efficiency of an Otto cycle determined?
The ideal Otto cycle achieves the Carnot efficiency of an engine working between the maximum, pre-combustion, temperature and the intake temperature. This means that the ideal Otto cycle cannot achieve the Carnot efficiency determined by the highest and lowest temperature during the cycle.
How does compression ratio affect the efficiency of the Otto cycle?
The influence of compression ratio and specific-heat ratio on the thermal efficiency of the Otto cycle is shown in Fig. 3. For a given specific-heat ratio, thermal efficiency increases dramatically with increasing compression ratio at low values of r.