What would cause a golf cart not to start?
If you try to start your cart and don’t hear that “click,” it’s likely an issue with your solenoid. If you’re lucky, the problem could be as simple as a loose wire or a broken coil. In some cases, corrosion can also be a factor. If you suspect a faulty solenoid, your best bet is to take your cart to a repair shop.
Why do I have to hit my starter with a hammer?
Hitting it hard can cause damage. As someone else stated, this is generally a last-ditch effort to start the car until the starter can be fixed or replaced. One person can do it, you do not need the key to be turned. It is usually a last ditch effort for a starter that has a failed component.
How do you bypass a solenoid on a golf cart?
Bypassing Golf Cart Solenoid Method If you do decide to bypass the solenoid, this is what you need to do: Take the two larger wires that connect to the solenoid and connect them directly (keeping all safety precautions in place). This should do the trick and if it does not work then the solenoid is not the problem.
Where is the reset button on a ezgo golf cart?
Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
Why does hitting a starter make it work?
Banging on the starter can sometimes give enough of a jolt to the brushes where they will once again have the correct contact with the commutator and will allow electricity to flow.
How do you unstick a starter?
Tapping the Starter Another method to loosen a stuck gear is to tap the starter with a hard tool, such as a wrench. However, you need to know the location of the starter motor on your car and be able to distinguish it from other parts. When you have located the starter, gently hit it with the hard tool.
Does a ezgo golf cart have a reset button?
Locate the motor Go to the back of the golf cart and find the panel that covers the electric motor. Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button. Push the button to reset the motor.