How can I reset the service light on my Chevy Silverado?
Below are some ways you can try to reset the light. The computer checks for errors whenever the key is turned in the ignition. If the problem causing the error has been fixed, try turning off the ignition, waiting ten seconds, then turning it on again. You’ll see the light come on for a few seconds and it will either go off or stay on.
When does the Check Engine light reset itself?
Reset onboard diagnostic computer. If you are sure that you have fixed the problem that the Check Engine light was showing up for, the engine light will reset itself after 10-20 successful cycles. A cycle is when the car is cold and started until it’s at operating temperature.
How do you remove a check engine light?
Erasing the Code (Old Way) Disconnect your car’s battery by removing the positive and negative cables. Press and hold your horn for 30 seconds to drain any remaining electricity from the capacitor. Wait 15 minutes and reconnect your battery.
What to do if your Chevy Silverado is running poorly?
Check the fuel cap. Sometimes poor quality fuel will also trigger the emissions system if it causes the engine to run poorly. If this occurs, try changing to a higher quality fuel or switching to a different brand. You’ll need to have a full engine and may have to drive around a bit before the light turns off. Have the key out of the ignition.
Below are some ways you can try to reset the light. The computer checks for errors whenever the key is turned in the ignition. If the problem causing the error has been fixed, try turning off the ignition, waiting ten seconds, then turning it on again. You’ll see the light come on for a few seconds and it will either go off or stay on.
What does a check engine light mean on a Chevy Silverado?
A check engine light can indicate a broad spectrum of problems with your 2004 Chevrolet Silverado 1500. In some cases you need to pull over immediately to prevent damage while in others you merely need to tighten you gas cap next time you stop in order to reset the service engine soon light.
What’s the best way to reset a check engine light?
In such a case, it is highly recommended to check the codes with a scanner instead. Switching the ignition on and off is also one method of hard reset without disconnecting batteries. Put the keys in your ignition and turn your ignition on and off consecutively after a second in each step.
When does the service engine light come on?
The service engine light will sometimes trigger whenever the computer detects a change in your truck. Here are a few things you can try to reset this light. This article applies to the Chevrolet Silverado 1500 (2014-Present).