How do you reset a Whirlpool Duet washing machine?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.
How do I reset my GE front load washer?
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
Does a GE washer have a reset button?
Unplug the washer for one minute, then plug the washer back into the electrical outlet and lift and lower the lid six times within 12 seconds. This will reset the motor and you should be able to start the cycle.
Why is my ge washing machine not spinning?
The washer will shut itself down to prevent any further damage. If your washing machine fills and agitates (washes) but doesn’t spin, the problem could also be with the lid switch, which tells the washer the lid is closed but may become dislodged by the vibrations of the spin cycle.
How to troubleshoot a ge top load washer?
1 Lid switch: The lid switch confirms that the lid is closed, allowing top-load washers to proceed with various stages of the cycle: fill, wash, drain, spin. 2 Pump: The pump actively removes water from your machine at the end of a cycle. 3 Drain hose: Your drain hose could have a kink or blockage that prevents drainage.
Why is my duet washing machine not working?
This error is saying that the motor control board has gotten too hot and may need to be replaced. The Duet washer uses a pressure sensing switch to detect the water level in the wash tub. The sensor uses a small tube that is attached to the outer tub.
Why does my ge front load washer shake?
If you are experiencing excessive washing machine vibration and shaking with your GE front loader washer, the first thing you need to rule out is the possibility that you simply had an off balance load.