Where is the seat belt supposed to be?
The lap (lower) part of the belt should be sitting low and tight across the upper part of your hips. It should never go across the upper half of your belly. The shoulder part of the seat belt should fit snugly across your chest and shoulder, not under your arm or across your neck or face.
Where can I get a replacement seat belt?
You can replace the bolt with a new replacement one purchased from Wesco and found in our 3 point retractable Replacement Seat Belts Optional Hardware Kit (part # 3pt-rmk) or the hex bolt (7/16″ fine thread Grade 5 or better) from the old seat belt if the car has never been in an accident. (The hex bolt should be firmly tightened.)
How to disable the seat belt alarm on your car?
How to Disable a Seat Belt Alarm 1 Beware of the airbag risk. 2 Check the user manual or ask your reseller to disable it per software. 3 Disable your alarm. See More….
How do you put a seat belt on a car?
1.) Remove both sill plates using a Phillips head screwdriver. 2.) Remove the gas pedal by removing the two 7/16” bolts securing it as shown on page 3. 3.) Remove the seat adjustment knob. 4.) Remove the lower and side seat wrap arounds. 5.) Remove the four rear bolts holding the front seat in place. 6.)
Are there any seat belt laws in the United States?
Most seat belt laws in the United States are left to the states and territories.
You can replace the bolt with a new replacement one purchased from Wesco and found in our 3 point retractable Replacement Seat Belts Optional Hardware Kit (part # 3pt-rmk) or the hex bolt (7/16″ fine thread Grade 5 or better) from the old seat belt if the car has never been in an accident. (The hex bolt should be firmly tightened.)
Which is the best seat belt to buy?
The BWOGUE Pet Seat Belt and Harness is the most affordable option on the list. It’s made of high-quality nylon fabric. A looped-design is meant to secure behind the headrest for added stability. The BWOGUE Pet Seat Belt and Harness is the most affordable option on the list.
How do you install a seat belt with carpet?
With the seats and carpet out you can begin the first part of the seat belt instal- lation. 1.) Measure and drill 13/32” holes through the floor pan as required by the chart on page 3. 2.) Secure the belts using the hardware supplied. CARPET INSTALLATION After the carpet and seats are back in we can finish the seat belt install. 1.)
How to Disable a Seat Belt Alarm 1 Beware of the airbag risk. 2 Check the user manual or ask your reseller to disable it per software. 3 Disable your alarm. See More….