How do you install an IP timing gear?
Apply sealant to the timing cover and install over the IP timing gear. Thread the 4 bolts in very loosely to make installation of the IP easier. Align the slot in the IP to mate with the dowel in the 4 o’clock position. Install the IP to engage with the IP timing gear about half way.
What’s the best way to set timing on an IDI?
Install the washers and nuts on the IP before fully engaging the IP. Install the IP shaft to timing gear bolts (the 12 point ones). Tighten the timing cover bolts. Now align the timing marks on the IP and timing gear cover. If you didn’t previously note the how your timing was set, this is a good place to start.
What’s the best way to check your timing number?
To check your timing number and see how it is firing, have someone rev the engine while you illuminate the timing numbers with your light. You obviously want to make sure the car is in neutral, and keep your hands a safe distance from the engine as it revs.
What do I need to adjust the timing on my car?
Your timing must be at the correct setting for your car to perform at top level, affecting the speed and efficiency at which the engine fires. You can adjust your car’s timing with a timing light and a set of wrenches, tools available at any auto parts store.
Where are the timing marks on a camshaft?
Without the marks, you would have to remove the pulley to check the crank pulley timing mark for TDC and then make your mark on the cover. On the pulley, the first mark on the left of pulley is 0 with increment of 5 degrees.
How to change the timing on a Nissan pickup?
1. Remove front cover. Carefully remove chain tensioner. DO NOT lose spring. Remove chain guides. Remove camshaft sprocket bolt, ensuring camshaft does not rotate. Remove timing chain and camshaft sprocket. disconnected. 2. Remove oil slinger (if equipped). Remove oil pump drive gear (note installation direction). Remove crankshaft sprocket.
To check your timing number and see how it is firing, have someone rev the engine while you illuminate the timing numbers with your light. You obviously want to make sure the car is in neutral, and keep your hands a safe distance from the engine as it revs.
What are the bright links on a timing chain?
Locate marks or “bright” links in your timing chain. These links are brighter than the other links and are used to align your engine. Set your engine to top dead center. To get your engine to top dead center, line the bright links on the timing chain up with the marks on your camshaft and crankshaft gears.