How do you reset the oil light on a 2010 Honda Civic?
2010 Honda Civic Change Oil Light Reset
- turn key to on position.
- Hold far left sel/reset switch.
- wait 10 seconds , oil life will flash.
- release finger from sel/reset switch.
- depress sel/reset button again for five seconds, dash dsiplay will change to milage.
How to reset the oil change light in a car?
Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF. Start the engine and make the sure the oil change or maintenance light is now OFF. If it’s still ON, repeat the reset procedure.
How to reset oil change light on GMC Vic?
The Chevrolet GMC models that come with a VIC or the models that introduce from 2006 are going to have the benefit from the following procedure: Turn the ignition key to the accessory position. With the oil message displayed, locate the enter button on the driver information center. Press and hold the button for one second.
How to reset the oil light on a Subaru?
1. Turn the ignition to run (one position before starting engine). 2. Select Settings using the steering wheel controls (up or down arrow). 3. Press and hold the SET button until given audible co… How to reset the maintenance interval on 2012-2015 Subaru vehicles equipped with the multi-information display.
How do you reset the oil change light on a Jeep Wrangler?
For certain Jeep products, including the Wrangler, how to reset an oil change light is as follows: Insert the key into the ignition and turn it to the “on” position without starting the engine. Depress the gas pedal slowly three successive times within 10 seconds. At this point, the system should have reset.
How do you turn off the change oil light?
Watch for the change oil light to flash. If it does not flash and remains on, turn the ignition key to the off position and then retry the procedure. After the change oil light flashes, it should go out. If the change oil remains on for five seconds (depending on the year and model Chevy), it may not have reset.
How do you reset oil change indicator?
Hold the button down until the “Oil” icon or word starts to flash, or the indicator lights show some other sign of resetting. Some cars will flash the word “Reset,” or display the numeral “100” to show that 100 percent of oil life remains after the oil change. Turn the ignition off, wait a few moments, and then start the engine.
How do you reset oil life?
On all vehicles, the Engine Oil Life System can be reset as follows: 1. Turn the ignition to ON/RUN with the engine off. 2. Fully press the accelerator pedal slowly three times within five seconds. 3. Display the OIL LIFE REMAINING on the DIC. If the display shows 100%, the system is reset.
How do you reset the change oil light on a Chevy?
Reset Oil Change Due Light on Chevy HHR Procedure: 2006-2011. Turn ignition switch to ON position with engine off. Press the INFO and RESET buttons on the DIC at the same time to enter the personalization menu. Press the INFO button to scroll through the menus until you see “Oil-Life Reset”.