What is tongue and groove walls?
Tongue and groove is a method of fitting similar objects together, edge to edge, used mainly with wood, in flooring, parquetry, panelling, and similar constructions. Each piece has a slot (the groove) cut all along one edge, and a thin, deep ridge (the tongue) on the opposite edge.
Can you use tongue and groove for walls?
Installing tongue and groove wood paneling on walls or ceilings is an easy way to add a new look and a sense of coziness to any room. Installation of tongue and groove paneling, even for those with limited knowledge or skills, can be done by every do-it-yourself weekend warrior.
What is the difference between shiplap and T&G?
The main difference between shiplap and tongue and groove is in the profile. Once installed, shiplap and tongue and groove look very similar. Tongue and groove planks, however, have a small projection sticking out of the center of one side’s edge, while the other side has a corresponding small indentation.
Should you paint tongue and groove before or after installation?
Tongue-and groove-ceilings must be stained before installation for best results. If, however, the builder hung the roof without staining it first, finish the ceiling in the method suggested in the tips section. Then you’ll have to touch up the unstained portions of the tongue as they become exposed over time.
How can I make my tongue and groove tight?
Solutions. If the tongue and groove fit is slightly tight, fold a piece of sand paper over the tongue and run it up and down a few times. Follow this by brushing off the excess dust. This will often ease the fit causing fewer difficulties.
What kind of nails do you use for tongue and groove?
We recommend using 16- or 18-gauge finish or brad nails. 1-½” to 2” in length should be sufficient. Both gauges are strong enough to hold the lumber securely, but small enough as to not leave a large hole on the face of the board.