What does UL1015 mean?
What is UL1015 Wire? UL 1015 hook-up wire is a PVC hook-up wire which is an Appliance Wiring Material (AWM) style that is based on the requirements of UL Standard 758, Appliance Wiring Materials. AWM 1015 is a general style for a single conductor wire that has an 80, 90 or 105°C temperature rating.
What size wire do I need for 110 amps?
Wire Size and Amp Ratings
| Wire Size | 60°C (140°F) | |
|---|---|---|
| AWG | (mm²) | Copper |
| 3 | (26.7) | 85 |
| 2 | (33.6) | 95 |
| 1 | (42.4) | 110 |
What size wire do I use for 150 amp service?
| SERVICE ENTRANCE CONDUCTORS SIZE AND RATING | ||
|---|---|---|
| Service or Feeder Rating | Copper Conductors | Aluminum or Copper-Clad Aluminum |
| 100 Amps | #4 AWG | #2 AWG |
| 125 Amps | #2 AWG | #1/0 AWG |
| 150 Amps | #1 AWG | #2/0 AWG |
What size ground wire do I need for a 100 amp subpanel?
You are correct that for a 100A feeder, the associated ground wire needs to be an 8AWG copper or 6AWG aluminum wire.
Is Thhn and THWN the same?
THHN stands for Thermoplastic High Heat-resistant Nylon-coated. THWN wire is the same, but the “W” stands for water-resistant. The main difference between these two standards is their maximum temperature in wet locations. However, most of these wires, so you can use THHN and THWN interchangeably.
What is UL1061?
UL1061 wire and UL1007 wire are both UL approved, single conductor wires commonly used for the internal wiring of electronic equipment. They are part of the classification known as hook-up wire and lead wire; they’re both similar in size, material, and overall construction.
What size wire is good for 100 amps?
When it comes to the lines connecting master and secondary panels, where the line will carry as much as a full 100 amps, use a 2-gauge non-metallic sheathed electrical cable. The cable must contain one or two hot wires depending on your needs, one neutral wire, and one ground wire. Each wire should be 2-gauge in size.
What size wire do I need for a 100 amp sub panel?
#4
The cable must have a wire gauge sufficient to the amperage of the subpanel—a 100-amp subpanel requires #4 copper wires or, more commonly, #2 aluminum wires, for example.