How do you get a ring off its retaining?
To remove this ring, simply pry out the end using a small screwdriver or staple remover, and then spiral the ring out by hand. For larger size rings, Smalley also makes a removal tool, part number RT-108, that can be used to remove the rings. The end of the tool contains a slot to insert the tip of the removal notch.
How do you remove a retaining internal spiral ring?
To remove a Spirolox ring using a screwdriver or any flat blade tool/dental pick, insert the tool tip into the removal notch and pry out the end of the ring. You can then grab the ring and spiral it out of the groove.
How do you get rid of an internal retaining ring without holes?
If you need to remove a circlip that doesn’t have holes on the ends, it is recommended to use a pair of narrow tip pliers. The fine tips of the pliers should be able to securely hold the snap ring and enable careful removal.
What’s the best way to remove a ring?
For larger size rings, Smalley also makes a removal tool, part number RT-108, that can be used to remove the rings. The end of the tool contains a slot to insert the tip of the removal notch. The ring can then be pulled out radially, then up for removal. That’s all for this week, check back in two weeks!. Do you have your own questions?
How are retaining rings installed without tooling?
More often than not, Spirolox retaining rings can be installed by hand without tooling. This is done by separating the turns, inserting one end of the ring over the shaft (or through the bore) and into the groove, then spiraling the rest of the ring into the groove. Depending on your application, this process may not be so simple.
How do you put a retaining ring on a shaft?
This is done by separating the turns, inserting one end of the ring over the shaft (or through the bore) and into the groove, then spiraling the rest of the ring into the groove. Depending on your application, this process may not be so simple. Heavy-duty single-turn retaining rings and hard to reach grooves can make installation difficult.
What to do if your shower retention ring is stuck?
Give it a few sharp taps with a wrench or hammer and if you have a strap wrench give that a try. It won’t pinch it but you can also grab it if you get on the very end of it, away from the threads. If your hands are strong enough, on the 600 series or the newer monitor series you can oval the nut.