What is a metal boss?
Definitions. A shallow raised shape that is pressed into a sheet of material to increase the strength in a local area. Also called embossment.
What is a cylindrical boss?
A boss is a cylindrical or rounded knob that projects from the surface of a part and provides a place for another object to attach onto it.
What is a screw boss?
Boss features are commonly found in injection molding designs. They are used to aid in the assembly of molded parts by providing a channel for a screw. You will want a thick enough wall so that the screw can engage with the plastic without splitting the post.
What is mounting boss in Solidworks?
The mounting boss feature can be found under Insert> Fastening feature > Mounting Boss. The mounting boss command requires a face or 3D point on which to locate the geometry on. The procedure which I have found helpful is to select a face in the general position that you want the boss to go.
What is a Viking boss?
The type of shield used by the Vikings can be traced back to the Iron Age. It consists of thin planking, which forms a circular shape. In the middle is a dome of iron to protect the shield bearer’s hand. This is called the shield boss and is often the only part which is preserved after 1000 years in the ground.
What is a boss screw?
In engineering, a boss is a protruding feature on a work piece. A common use for a boss is to locate one object within a pocket or hole of another object. A boss may also refer to a mounting feature that will receive a screw or thread-forming screw.
What is a boss bushing?
As nouns the difference between bushing and boss is that bushing is (mechanical engineering) a type of bearing, a cylindrical lining designed to reduce friction and wear inside a hole, often used as a casing for a shaft, pin or hinge while boss is boss (person in charge, supervisor).
What is a boss diameter?
What is a boss diameter? The boss itself has initially a diameter of 2.79 mm as recommended for the screw selected in Chapter 5.4 Screw. Therefore it is idealized to set the hole diameter r equal to the outer diameter of the screw of 3.7 mm.
What is difference between SIR and boss?
is that sir is a man of a higher rank or position while boss is a swelling, lump or protuberance in an animal, person or object or boss can be (obsolete) a hassock or small seat, especially made from a bundle of straw or boss can be a person who oversees and directs the work of others; a supervisor.
How do I use fastening features in Solidworks?
To create a fastening feature:
- Click a fastening feature tool (Fastening Features toolbar) or Insert > Fastening Feature, then select the type of fastening feature: Mounting Boss. Vent (Create a vent sketch first.) Snap Hook. Lip/Groove.
- Set the PropertyManager options, then click .
What is a stud on a shield called?
A shield boss, or umbo, is a round, convex or conical piece of material at the centre of a shield. The boss was originally designed to deflect blows from the centre of round shields, though they also provided a place to mount the shield’s grip.