How do you replace the springs on a car?
A few bolts fasten the springs to the brackets underneath the car. After undoing the nuts and bolts, replace them to their original positions with the new springs. Next time you operate your vehicle, it should feel more responsive and resistant to bumps in the road thanks to the new springs. Park the vehicle in a flat area.
Where does retainer sit on Honda S2000 head?
If you forgot the spring orientation, the end with the more closely-wound coils is the bottom end (i.e. it sits on the spring seat in the head); the retainer sits on the more loosely-wound top end. My original factory springs also had some paint on the top end.
How do you replace light bulbs on Honda S2000?
1. Remove the three gold screws holding the white plastic cover in place and gently lift the cover out of the way. There are connections between the two boards, so exercise caution. 2. Replace four bulbs. 3. Put it back together. 5. Button it all up Basically, do what you just did, but in reverse order. 1.
How do you remove a leaf spring from a wheel?
Support the spring as you slide out the bolts to prevent it from crashing down. Repeat the steps to remove the other leaf spring. The second leaf spring is next to the opposite wheel. Remove it by undoing the brackets, bolts, and screws. Set them aside to save them for later. Position the new leaf spring under the mounting brackets.
A few bolts fasten the springs to the brackets underneath the car. After undoing the nuts and bolts, replace them to their original positions with the new springs. Next time you operate your vehicle, it should feel more responsive and resistant to bumps in the road thanks to the new springs. Park the vehicle in a flat area.
What to consider before restoring your Honda S2000?
To replace your hood dampers, please see DIY $13 Hood Dampers in the S2Ki.com forum. >>Join the conversation about restoring your Honda S2000 right here in the S2Ki.com forum. There’s nothing like popping open your hood and looking at a crisp clean engine bay.
Where to install the sway bar on a S2000?
Install the rod end (the thicker part) on the rear of the control arm eyelet for the stiffer three settings and to the front of the control arm eyelet for the softer three settings. To reiterate- softest setting (#1) is furthest from the sway bar and the stiffest (#6) is the closest to the sway bar.
How can I check the springs on my valve?
Disassemble each spring (if multiple springs are employed at each valve). Check all the springs (both inner, and outer springs) If there is not 0.060″ – 0.100″ minimum of clearance between the coils, the solutions are: the valve retainer, the valve locks, the valve, or the spring must be changed; the spring pocket must be machined.