How do I remove the stand from my HP 24m monitor?
Lay the monitor on a flat, soft and clean surface. Press the button in red to remove the stand. Remove the screws. Remove the mainframe.
How do I remove the stand from my hp z23 monitor?
- Removing the Monitor Stand.
- CAUTION:
- Disconnect and remove the signal, power, and USB cables from the monitor.
- Lay the monitor face down on a flat surface covered by a clean, dry cloth.
- Pivot the stand 45 degrees clockwise and remove the lower right mounting screw from the back.
How do I remove the stand from HP Elitedisplay e231?
- Disconnect and remove the signal, power, and USB cables from the monitor.
- Lay the monitor face down on a flat surface covered by a clean, dry cloth.
- Pivot the stand 45 degrees clockwise and remove the lower right mounting screw from the back.
What is monitor pivot adjustment?
Monitor pivot is a feature on many monitor models which increases the number of viewing options at your disposal. Monitor pivot refers to a monitor’s ability to rotate the display, changing the aspect ratio from a widescreen format to a vertically inclined long format.
What is swivel adjustment monitor?
Adjust the viewing angle left and right as shown in the illustration. Swivel is available depending on the TV size. When adjusting the angle, hold the stand with one hand to avoid having the stand slip or tip over.
How do I remove the stand from my Dell monitor s2319nx?
Use a long and thin screwdriver to push the release button. 4. While pressing on the release button, pull the stand out. Press the button to turn On the monitor.
How do I remove the stand from my Dell monitor st2420l?
Removing the Monitor Stand Use a long screwdriver to push the release latch located in a hole just above the stand. 2. Once the latch is released, remove the base away from the monitor.
How do I remove the stand from my HP la2205wg?
Lay the monitor face down on a flat surface covered by a clean, dry cloth. Pivot the base 45 degrees clockwise and remove the screw from the back of the monitor, then pivot the base 45 degrees counter-clockwise and remove the other screw from the back of the monitor.