Where is the fuel pump in a Honda Civic?
Once the fuel pump strainer is out, perform the following steps: Disconnect the top plug. Remove the strainer clamp. Pull out the pump. Figure 5. Be careful not to drip any fuel while removing the pump strainer. Figure 6. The fuel pump is located inside the metal cylinder/canister.
Where is the fuel pump fuse box located?
The engine’s or the dashboard fuse box is usually a long black box containing a fuel pump relay and various other fuses and relays. For different vehicles, the fuel pump relays can be located in different places.
What to do if your fuel pump is not working?
Check out your vehicle’s service manual to find out where to check and the proper procedure for checking it. Test for source voltage, to determine whether or not the good charge that’s leaving the fuse is getting to the pump. If no power is making it to the fuel pump, then check the fuel pump relay circuit.
Where is the fuel pump relay located in a car?
You can try to listen closer around the fuel tank for any noise for 2-3 seconds after turning the ignition on. Where is the Fuel Pump Relay Located? In most car models, the fuel pump relay is located in a fuse box somewhere under your dashboard, but it can also be located in the fuse box in the engine bay.
Where does the gas pump go in a Honda Civic?
Its role is to pump the gas from the gas tank—through the fuel lines—to the engine. While fuel pumps are fairly reliable, once your Civic gets up in miles it’s just a matter of time until it needs to be replaced. Thankfully, this is quite simple in the 1992 through 2000 Honda Civic.
How can I tell if my Honda Civic fuel pump is bad?
Testing your Civic’s fuel pressure on each side of the pump would be the best way to diagnose this problem. A priming fuel pump sounds like a high-pitched whine for a few seconds and can be heard with a sharp engine right after the ignition key is turned, but before the starter is engaged.
How can I check if my fuel pump is working?
Before you check your fuel pump, find the fuse that corresponds to the pump and pull it out to see if it is broken or burned. If it looks fine, check the voltage at the pump itself to make sure the charge that’s leaving the fuse gets to the pump. If this looks alright, then perform a fuel pressure test.
What to do if your fuel pump fuse is blown?
Check in your owner’s manual for the location of the fuse box, then find the fuse that corresponds to the fuel pump. Pull it out and inspect it for signs of failure. If the fuse is blown, it will be broken or burned.