Why my car is showing ABS light on?
The four common reasons that typically cause this light to turn on include a malfunctioning ABS module, low levels in the fluid reservoir, broken wheel speed sensors, or the system is turned off. Your ABS actually shares some important components with another system in your vehicle: your traction control system.
How do I get my Honda ABS to go off?
Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it). The ABS indicator will come on, but then should go off, at this point release the brake pedal (some have found better success by releasing the pedal quickly after the light comes on).
How to fault reset Honda ABS and VSA?
Honda ABS / VSA Fault Reset Procedure: Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it).
What does the ABS light mean on my car?
What the ABS light means. The ABS system uses sensors at each wheel to monitor their rotational speed. A computer monitors the signals from all four wheels and the position of the brake pedal to make sure that the vehicle is stable and under control. If the computer notices any abnormal signals, or the lack of a signal from any of the sensors,…
What should I do if my Honda Passport is having problems?
I have a 1996 Honda passport and have noticed that the alternator and or battery is the suspected electrical problems in most Honda Passports and you should loosen the alternator; then make sure the electrical plug is properly and tightly plunged into the alternator. If this doesn’t help go to auto zone and they will check your alternator for free.
Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it). The ABS indicator will come on, but then should go off, at this point release the brake pedal (some have found better success by releasing the pedal quickly after the light comes on).
Honda ABS / VSA Fault Reset Procedure: Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it).
Why does my Honda ABS light keep coming on?
It sounds like you have a dead battery. The procedure is intended to clear the ABS/VSA error lights that often occur due to a low voltage “glitch” from a dead or weak battery. If you have a weak or dead battery get that fixed before you do anything else.
Where are the short pins on a Honda dash light?
Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. I used a paper clip, but any stiff (solid) light gauge wire will do. Click on the photo below right to expand and you can see the pin numbers marked in the plastic.