How to replace stabilizer bar on Honda Odyssey?
This eight-minute video will provide you with visual step-by-step help for completing the removal and replacement of a Honda Odyssey upper strut mount (including new bearings) and the stabilizer bar link. The steps are also described lower down in the article. Step-by-Step Instructions: Honda Odyssey Strut Mount and Stabilizer Bar Replacement
Are there any Honda Odyssey parts that can be repaired?
As a result, we provide an extensive selection of high quality Honda Odyssey repair parts manufactured to restore your vehicle to like new condition at the most attractive prices. No matter whether you are changing an air filter or doing a routine brake job on your Honda Odyssey, we have everything for your repair and maintenance needs.
How to replace the upper strut on a Honda Odyssey?
Turn the strut mount until the studs are lined up with the chassis mounting mounts. The new strut should have a alignment mark pointing to the front of the car. 1. If you plan to replace the stabilizer bar link, remove the old link from the stabilizer before re-installing the suspension strut.
Why is my Honda Odyssey making a noise?
This bearing was the cause of at least one of the noises. The other noise was coming from a worn-out stabilizer bar link. The lower ball-in-socket connection point had worn out, resulting in metal-to-metal contact without any grease lubricant. Replacing both parts eliminated all noises from the left front corner of the car.
Do you need to replace front wheel bearings on Honda Odyssey?
Replaced both front wheel bearings. Front wheel noise when turned at low speed. Heard loud noises while driving, but thought it was just the engine noise. Took the car to Honda dealer and was told that I need to replace both wheel bearings. I think the 2005 Honda Odyssey is one of the most problem-prone vehicles that Honda has ever produced.
How can I tell if my Honda Odyssey has bad bearing noise?
Test Drive – The best way to diagnose bearing noise in your Odyssey is to take it for a drive. You’ll be looking to hear the hum increase as the speed picks up. Jack and Wiggle – With your Odyssey on jack stands, you’ll want to look and see if the wheel is wiggling at the bearing.
What is the problem with Honda front wheel bearings?
Problem just started. Drivers side wheel bearing vibrates badly especially when under torque loading i.e. Accelerating or going uphill. Must let off on throttle to mitigate vibration. These are pressed in bearings so the knuckle must be removed to replace the bearing Known issue that Honda should have recalled.
How much does a Honda Odyssey general diagnosis cost?
The average cost for a Honda Odyssey General Diagnosis is between $88 -$111. Learn More I hear loud noises while driving, I’m sure it’s not the engine..