How do you change the bearing race on a rotor?
You don’t want grease to be between the race and the hub surface because it will lubricate the race which is a press fit. This will cause the race to become lose and ruin the rotor. Set the new bearing race cone facing outward squarely into the rotor hub. Next, position the old bearing race on top off the new race.
How to replace wheel hub and bearings on Acura TL?
Remove the 17mm nuts near the cotter pins. Disconnect the ABS sensor by removing the 10mm bolts from the knuckle (#15 and 19 Figure 1). Use the tie rod end puller/separator to remove the upper and lower control arm and tie rod end from the knuckle.
How do you replace a wheel bearing on a Honda?
Secure the steering knuckle on a vice. Remove the circlip. Thread the long bolt with cup and adapters from your wheel bearing adapter kit through the wheel bearing, and attach a 32mm hub socket to the other end. Torque the socket to press the wheel bearing loose.
What happens when wheel hub and bearings wear down?
You might also experience uneven tire, rotor, or brake pad wear and vibrations at speed. As bearings wear down even farther, they can become quite dangerous and even damage other suspension components in the process, so it goes without saying that you shouldn’t ignore the problem.
Remove the 17mm nuts near the cotter pins. Disconnect the ABS sensor by removing the 10mm bolts from the knuckle (#15 and 19 Figure 1). Use the tie rod end puller/separator to remove the upper and lower control arm and tie rod end from the knuckle.
Secure the steering knuckle on a vice. Remove the circlip. Thread the long bolt with cup and adapters from your wheel bearing adapter kit through the wheel bearing, and attach a 32mm hub socket to the other end. Torque the socket to press the wheel bearing loose.
How to upgrade Honda Civic DX brake rotors?
take the ex/si knuckle (with bearing and hub) and bolt on the 17cl14vn 90-93 integra calipers, caliper mounting brackets, rotors, and pads and swap them onto the civic dx. take the ex/si knuckle (with bearing and hub) and bolt on the 17cl14vn 94-01 integra calipers, caliper mounting brackets, rotors, and pads and swap them onto the civic dx.
Where are the wheel bearings on a car?
This is because the front rotors are often behind the front hubs, which means that to change the rotors you have to pull the hubs off the front spindles, at which point the bearings are practically in your hand. So, if you need to do a front brake job, check the wheel bearings.