How do you configure dual WAN on FortiGate?

How do you configure dual WAN on FortiGate?

To configure the routing of the two interfaces using the GUI:

  1. Go to Network > Static Routes, and click Create New.
  2. Enter the following information: Destination. For an IPv4 route, enter a subnet of 0.0. 0.0/0.0. 0.0 .
  3. Click OK.
  4. Repeat the above steps to set Interface to wan2 and Administrative Distance to 20 .

What is WAN failover?

What is WAN Failover? WAN failover helps prevent disruption of network connections and application access by monitoring WAN performance and connection health, identifying an outage or other failover event and rerouting traffic to an active connection.

How does WAN failover work?

WAN Failover works in conjunction with multiple ISPs to assure that you maintain Internet connectivity if a loss of connectivity occurs on one of your WAN connections. If one of your ISP links goes down, WAN Failover will automatically route all traffic over the other WAN(s) until service is restored.

How can I check my FortiGate firewall Internet connection?

To run an interface speed test from the GUI:

  1. Go to Network – > Interfaces.
  2. Edit a WAN interface.
  3. Select ‘Execute speed test’ in the right panel.
  4. When the test completes, select ‘Apply results’ to estimated bandwidth.
  5. Select ‘OK’.

What is Link Monitor FortiGate?

FortiGate. Description. Link health monitoring measures the health of links by sending probing signals to a server and measuring the link quality based on latency, jitter, and packet loss. Link-monitor can be configured for status checks.

How do I test WAN failover?

Example: Use a ping test for WAN failover from Ethernet to…

  1. Click Network > Interface > ETH2 > IPv4 > SureLink.
  2. For Interval, type 10s.
  3. Click to expand Test targets.
  4. Delete the existing test targets:
  5. For Add Test Target, click .
  6. For Test type, select Ping test.
  7. For Ping host, type 43.66.

What is the difference between WAN failover and load balancing?

WAN Failover enables you to configure one of the user-defined interfaces as a secondary WAN port. You can select a method of dividing the outbound WAN traffic between the two WAN ports and balance network traffic. Load-balancing is currently only supported on Ethernet WAN interfaces, but not on WWAN interfaces.

How do I get full Internet access on FortiGate firewall?

How to Setup FortiGate Firewall To Access The Internet

  1. Login to the FortiGate’s web-based manager.
  2. Configure the internal and WAN interfaces.
  3. Go to system –> Network –> Interfaces.
  4. Configure the WAN interface.
  5. Configure the internal interface.
  6. Review the Configuration.
  7. Configure default route at.

How do I access FortiGate firewall from outside?

Fortinet Firewall Management Interface Access Over WAN

  1. Step 1: Allow HTTPS on Management Interface. On GUI, Network > Interfaces, on Administrative Access section, allow HTTPS.
  2. Step 2: Permit Public IP Addresses.
  3. Step 3: Change default https port to 444.

How do you perform a failover in FortiGate?

To manually force an HA failover.

  1. # execute ha failover set 1. Caution: This command will trigger an HA failover.
  2. # execute ha failover status. failover status: set.
  3. # get system ha status. HA Health Status: OK Model: FortiGate-300D.
  4. # execute ha failover unset 1.
  5. # get system ha status.