What is the Essex table used for?
The multi-functional 70-inch Essex console can be used as a sofa table, a serving piece in the dining room or an entry piece in the front hall.
What does a frame square do?
Also known as a steel square, the Johnson framing square is a handy tool for carpentry. Its uses extend into framing and laying rafters and stairs. It can also be used as a straight-edge, finding and establishing right angles and marking cut-off work on widestock.
What is the most often used table on the framing square?
The most important set of numbers on the framing square are the rafter tables. These are located on the face side of the body.
What tables are on a framing square?
Here we describe how to use the rafter tables found on the front blade on a framing square. The rafter tables allow you to calculate the length of a rafter by choosing a “full scale” number that matches the unit rise (slope or angle) of the roof.
What is a Essex table?
noun Carpentry. a chart tabulating the number of board feet, to the nearest twelfth, contained in pieces of wood one inch thick and of varying standard sizes.
What is Essex board?
Essex Board is a sheet material made from compacted paper fibres. It is lighter than mdf or hardboard and easy to work with. It is commonly used in the manufacture of pelmets.
What is the number 17 used for on a framing square?
Laying out a hip rafter with the framing square requires the square to be set on a unit run of 17 inches (16.96 inches rounded off to 17) instead of the 12-inch run used for commons.
How deep should pelmets be?
We would recommend that the depth of the pelmet track (B) should be at least 10cm deep. We recommend 15cm. This is to ensure that when the curtains are drawn back, they do not push against the pelmet.
What can you do with a framing square?
A framing square is a lot more than a simple square-cut saw guide. This simple device is crammed with tables, data and tricks that allow a carpenter to lay out roof rafters, stairs, or other building features. A carpenter’s framing square includes tables stamped right into the tool itself.
What is the Essex Board measure on a framing square?
Found on the back of some older framing square blades – but not on most modern framing squares, the Essex Board Measure will tell you the number of board feet for lumber of various lengths, widths, thicknesses. One Board Foot is the volume of wood that is found in a one-inch thick square that is 12×12 inches in length and width.
How does the rafter table work in a framing square?
At first glance the rafter table stamped into the side of a framing square can be a bit tricky to understand. But it is not so difficult once you get the hang of it. The first thing to understand is that it is based on roof pitches expressed in amount of rise (vertical) over a 12 inch run (horizontal).
How do you read a framing square on a table?
How to Read a Framing Square Place the framing square on a table with the skinny length pointing right. The skinny length is called the tongue. The thicker, longer section is called the blade. The corner of the framing square is called the heel. On the face side, the tongue reads the eight square scale. Flip the framing square.