What kind of grease does a Honda car use?
Looking for a solution, the American arm of Honda found an existing fix in the global parts catalog: Shin-Etsu grease. Service departments then made it part of their response to squeaks and leaks.
Where are grease fittings on front wheel drive car?
You may find fittings on tie rod ends, upper and lower ball joints, sway-bar links and control-arm pivots, so hunt around and make sure to hit them all. There might be grease fittings on as many as three U-joints on the driveshaft (or shafts), depending on whether you have a front-wheel-drive, rear-wheel-drive or four-wheel-drive vehicle.
What are the dimensions of a 1999 Honda CRV?
Legroom (in., front/rear): 41.5/36.7 Shoulder Room (in., front/rear): 53.3/55.5 Hiproom (in., front/rear): 53.4/50.7 Cargo Volume (cu. ft., seat up/down): 29.6/67.2 Passenger Volume (cu. ft.): 98.0 Wheelbase (in.): 103.2 Length (in.): 177.6 Height (in.): 65.9 Width (in.): 68.9 Track (in.,…
Can you use a grease gun to lubricate a car?
Some vehicles still come with suspension and driveline parts that have proper grease fittings, allowing you to use a simple hand-pumped grease gun to inject precious lubrication at regular intervals. Virtually all aftermarket parts, even the direct replacements for the sealed factory units, have grease fittings to allow for lubrication.
Looking for a solution, the American arm of Honda found an existing fix in the global parts catalog: Shin-Etsu grease. Service departments then made it part of their response to squeaks and leaks.
Where can I get Shin Etsu grease for my Honda?
As miracle cure, Shin-Etsu grease isn’t limited to door seals. It works anywhere that you don’t want to use a petroleum-based product, such as window regulator tracks. If you want your own tube, the Honda part number is 08798-9013, available at the parts desk or any number of online retailers.
Are there grease fittings on a Honda ATV?
Your not going to find any grease zerks unless you add them yourself. Honda would rather use oil impregnated bushings and have you do less maintenance, then end up replacing every bushing in the suspension for mucho dollars later on. Your not going to find any grease zerks unless you add them yourself.
Where are the grease fittings on a Honda Arctic Cat?
My old Arctic Cat, all the a arm bushings and ball joints where totally shot after 5,000 miles. You will have to install zerks. Its an overlooked necessity. Your not going to find any grease zerks unless you add them yourself.