How do you connect a battery to a lighter?
Run a wire from a permanentlive feed to the centre terminal on the socket. Fit an in-line fuse to this wire (35 amp). Join a wire to the earth terminal on the casing and run it to a convenient point on the body. Reconnect the battery and test the lighter.
How do you hook up a cigarette lighter?
Wiring up Disconnect the battery for safety. Run a wire from a permanentlive feed to the centre terminal on the socket. Fit an in-line fuse to this wire (35 amp). Join a wire to the earth terminal on the casing and run it to a convenient point on the body. Reconnect the battery and test the lighter.
How do you make a socket for a lighter?
Cover your chosen area with masking tape to protect the surface. Use a pair of compasses to draw a circle on the masking tape slightly smaller than the diameter of the lighter socket body. This is to ensure you get a good tight fit for the lighter. Start by drilling a pilot hole in the centre of the marked circle.
How do you put a lighter in a dash?
Remove the masking tape from the dash or centre console. Remove the lighter element and casing from the socket body. Insert the socket into the hole from the front of the dash. Make sure the trim ring (if fitted) is in position under the head of the socket. Open the hole out a little more with the file if necessary.
How do you install a new light fixture?
Unpack your new fixture. Carefully lay out the parts so they are easily accessible. Turn off the power. Find your home’s circuit breaker or fuse box and turn off power to the room or area of the house where you’ll be installing the light. Failure to turn off the power before beginning work may result in serious electrical shock.
How to install a parking light tail light assembly?
Park the Toyota vehicle on a flat service and remove the keys from its ignition. Open the trunk, rear door or tail gate, depending on what type of Toyota vehicle you have.
How do you install a light on a ceiling fan?
Screw the lighting assembly onto the ceiling fan. This attachment should go smoothly, especially if you have purchased a lighting assembly designed to be attached to your ceiling fan. Install light bulbs, glass shades, and pull chains, following the directions provided by the manufacturer.
What are the steps to installing a pendant light?
Tighten screws if necessary, but do not over-tighten. Attach the power wires. Have an assistant hold the light fixture up to the ceiling while you connect the wires from the light fixture to those hanging out of the junction box. Connect wires according to the directions provided with the light.