How do you reset a sewer pump?
How to Reset a Sump Pump
- Locate the reset button on the motor. If there isn’t one, locate the on/off switch and turn it off, or unplug the pump directly from the electrical outlet.
- Look inside of the sump pump.
- Plug the pump back in or move the switch back to the on position if there was no reset button.
What happens if sewer pump stops working?
These pumps operate in a very harsh environment (submersed in sewage) and often fail after just a few years. Failure of your pump could mean sewage back-up in your basement. The risk of a damaging back-up is especially high if you have a water softener which drains into the sewage ejector system.
How do I know if my sewer pump is working?
To verify if the plug is working, you will need to follow the power cord from the ejector pump and see where it is plugged in. Pull the plug out and plug in something such as a light that you know should work. If the light doesn’t turn on, there is no power going to that outlet.
Why is my sewage ejector pump not shutting off?
Whether your sewage ejector pump not shutting off is the main trouble or its float switch that is behaving strangely, there are simple troubleshooting steps you can try out. Let’s know more below. Pump Not Cycling Right.
What should I do if my sewage pump wont turn on?
If it doesn’t turn on, the pump is bad, but replacing it ($300, including switch) is just as easy as replacing the switch—simply lift out the old pump and put a new one in. If the pump works, run water for a minute to flush out the dirty water—but don’t let the water level go below the pump or you’ll burn out the pump. Then remove the basin top.
When to call a plumber for a sewage pump?
However, if you have a major backup of effluent and the pump is running continuously for a long time, it is best to shut off the pump and call a plumber because you likely have an obstruction in your sewage discharge lines.
Why does my sewage pump keep burning out?
While bypassing the float switch temporarily is fine so you can eliminate waste in the holding vessel, this is not a long-term solution. The continuous power supply causes the pump’s motor to run nonstop. Therefore, the pump will burn out faster than it should if left connected to direct power.