What should I do if my temperature gauge reads 50 ohms?
If the sensor reads 30-50 Ohms when the engine is hot then there may be a problem with the wiring back to the gauge or with the gauge itself. Make sure the engine is turned OFF and that the vehicle’s ignition key is in your pocket when you test the sensor. Also don’t burn yourself on the engine block when the engine is hot Was this answer helpful?
Why is the temperature gauge pinned hot on my Honda?
Cut repair costs, not quality. Since you are experiencing no overheating problems the most likely cause is that the engine coolant temperature sending unit is faulty. This sends a signal directly to the dashboard gauge. There is another coolant temperature sensor close by which sends a signal to the ECU to help in engine management.
What should the temperature gauge be on a hot engine?
With a hot engine it should measure 30-50 Ohms. If you measure around this value (or definitely not near 140 Ohms) with a cold engine then the unit is faulty and needs to be replaced. A quick test is to disconnect the lead from the sending unit, turn on the ignition and observe the temp. gauge.
When does the temp gauge go up or down?
B16A2 DOHC VTEC engine. Currently has 204,000 kilometres (127,000 miles) When the car is on a stop and idling, the temp gauge needle goes up steadily, and when the car is running, the gauge goes back to normal just as fast. When the temp gauge is on hot and I rev the engine, temp gauge needle goes down a little bit.
Cut repair costs, not quality. Since you are experiencing no overheating problems the most likely cause is that the engine coolant temperature sending unit is faulty. This sends a signal directly to the dashboard gauge. There is another coolant temperature sensor close by which sends a signal to the ECU to help in engine management.
If the sensor reads 30-50 Ohms when the engine is hot then there may be a problem with the wiring back to the gauge or with the gauge itself. Make sure the engine is turned OFF and that the vehicle’s ignition key is in your pocket when you test the sensor. Also don’t burn yourself on the engine block when the engine is hot Was this answer helpful?
With a hot engine it should measure 30-50 Ohms. If you measure around this value (or definitely not near 140 Ohms) with a cold engine then the unit is faulty and needs to be replaced. A quick test is to disconnect the lead from the sending unit, turn on the ignition and observe the temp. gauge.
Why does my temperature gauge read hot and cold?
If it reads approx. 140 Ohm (or more) when the engine is both cold and hot then the sensor is faulty and needs to be replaced. If the sensor reads 30-50 Ohms when the engine is hot then there may be a problem with the wiring back to the gauge or with the gauge itself.