What to do with timing marks on paint?
Timings marks as they appear in the timing window. True TDC and 35° marks. Note: I punched a small dot on the case to eliminate guesswork. I recommend cleaning the timing marks with thinners, then painting with white marker pen or white paint and artist brush.
How are timing marks determined on a bike?
Timing marks, distributor-timer, log book. I checked my timing marks on the bikes’ flywheel. I used a degree wheel to accurately determine TDC. Then I moved the flywheel to the 35° point on the degree wheel (full advance). I drew pictures of the marks for reference. They were perhaps a degree out compared to factory pictures..
How to replace distributor and ignition timing adjustment?
Haynes manuals come with step-by-step procedures for many replacement, troubleshooting and maintenance projects. So you can recoup your investment in a short time while keeping the manual on hand for many more car projects. 1. Removing the Distributor 2. Installing the New Distributor 3. Ignition Timing Adjustment 4.
When to repair slop in timer shaft and bushes?
18 Dec 2019 The time came to repair the slop in the timer shaft and bushes. I bought sintered bronze bushes that were a bigger OD and smaller ID so I could turn them to exact dimensions. Studying sintered bronze showed the bushes aren’t supposed to be honed though reaming is OK if the reamer is very sharp.
Do you need timing light to replace distributor?
Find the timing specifications for your vehicle. Replacing the distributor requires you to use a timing light to set the timing of the engine after the new distributor is installed. To do this, you’ll need to use the timing specifications unique to your vehicle.
Where do I find the timing specifications for a distributor?
Find the timing specifications for your vehicle. Replacing the distributor requires you to use a timing light to set the timing of the engine after the new distributor is installed. To do this, you’ll need to use the timing specifications unique to your vehicle. Often, these are on a sticker under the hood or in the engine compartment.
How do you set ignition timing with no timing marks?
Rotate the engine very slowly back and forth until the screwdriver is at the maximum height. This indicates the number one cylinder is at Top Dead Center or “TDC” on the compression stroke. Locate the number one spark plug wire on distributor cap and make a tic-mark of this position with a marker pen on the distributor housing.
Where to mark the rotor on a distributor?
In other words, mark your old distributor’s rotor position inside the housing of your new distributor and mark the location on the outside of the distributor that lines up with your engine’s mounting point. Ensure that the rotor is in the marked position before installing.