Why is my Yale lock not working?
If you find that the issue is the lock, try rebooting the lock first. To reboot the lock, remove one battery from the lock and replace it. Once you have rebooted the lock, try the entry code again. If this does not work, the keypad must be reset.
How do I reset my Yale touch deadbolt?
To reset the lock to factory default, see the following: 2. The reset button (see image at right) is located above the PCB cable connector. 3. Hold down the reset button for a minimum of 3 seconds and then reinstall the batteries; once the batteries are properly installed, release the reset button.
Why is my Yale lock beeping?
Always be sure to check the battery status of your smart door lock because, in most cases, it turns out that low (or defective) batteries are the cause of the beeping of your smart lock. It is necessary to replace the batteries if they are completely depleted of power.
Why is my Yale lock flashing red?
When battery power is low, the status indicator flashes red. This is the most common reason for a red light on your Yale lock. In addition to the red light, the lock may also give a verbal warning that the batteries need to be replaced. When the door is unlocked, you can easily replace the batteries.
How do you calibrate a Yale lock?
Open the Yale Access App and navigate to the affected lock. Select Lock Settings. Scroll to and tap on Calibrate Lock. Follow in-app instructions to recalibrate.
How do I stop my Yale from beeping?
Yale Home App You can stop the alarm by disarming it using the app, a keypad, or a key fob. How do I turn off warning ‘beeps’ from my smart hub? In the app go to Settings-Alarm Settings-System Settings-General Configuration. Turn off Hub Warning Sounds and press Save.
How do you change the battery on a Yale touch screen?
1. Remove battery cover 2. Remove batteries 3. Remove the two screws behind the batteries 4. Remove the screw at the very bottom of the lock. 6. press the button on the circuit board just above where the wires are connected 7. Keep holding the button while you replace the batteries. 8. Release button once batteries are in
Why is my Yale Lock key not working?
Here are a few reasons your Yale lock keypad is not working. Misaligned Strike Plate. When the deadbolt and strike plate are out of alignment, the deadbolt strikes on the frame of the door when the door is locked, rather than extend fully into its keep. Even when a correct code is entered using the keypad, the lock remains unlocked.
What does blue light on Yale Lock mean?
My Nest X Yale lock is pulsing blue on the interior side of the lock. What does this mean? A blue pulsing light indicates that the lock is updating itself to a new version of the software. It should only take a few minutes to complete the process.