How to reset Honda CRV maintenance light after oil change?
To reset the 2016 Honda CR-V maintenance light after an oil change, please follow these instructions: Multi-Information Display: 1. Turn the ignition to run (one position before starting engine). 2. Press the (up/down) button to select Vehicle Settings, then press the SEL/RESET button. 3.
How to turn off the engine in a Honda CRV?
Turn off the engine. Press and hold the Select/Reset button on the instrument panel, then turn the ignition switch to the ON (II) position. Hold the button for about 10 seconds until the indicator goes off.
How do you reset the Honda Fit maintenance light?
1. Turn the ignition to run (one position before starting engine). 2. Press the SELECT/RESET knob repeatedly until the engine oil life indicator is displayed. 3. Press the SELECT/RESET knob for more than 10 seconds. The engine oil life indicator and the maintenance code (s) will blink. 4. Press the SELECT/RESET knob for more than 5 seconds.
How to reset the maintenance required dashboard indicator?
The Select Reset button is located between the E on the fuel gage and the odometer. While holding the Select Reset button down, turn the ignition switch to ON but do not start the vehicle. Hold the Select/Reset button in for about 10 seconds until the indicator light goes off.
How do I reset maintenance light?
Turn your vehicle’s ignition to the “acc” setting while holding the button. Do not crank the vehicle. Hold the position for five seconds and turn the ignition key off. Release the button. The maintenance light will be reset and will illuminate again the next time service is due.
How do I reset the required maintance light?
- Turn ignition switch to the ON position
- Trip Display to TRIP A mode
- Turn the ignition switch to the OFF position
- Depress and HOLD the Trip Meter RESET button while turning the ignition switch to the ON position.
How do I Turn Off the maintenance required light on my Honda?
How to Turn Off the Maintenance Required Light on a Honda Civic. Put the key in the ignition. Press and hold the odometer reset knob. This is the knob that sticks out on the bottom right of the instrument cluster. While holding this button, turn the key to the “On” position, but do not start the engine.