How do I log into my Cisco access point?
The default username is Cisco. Step 4 Enter the wireless device password in the Password field and press Enter. The default password is Cisco.
What is the default IP address for Cisco AP?
If the wireless access points do not receive a DHCP response (there is no DHCP server on your network) after 60 seconds, the access points will fallback to the following default static IP address: 192.168. 1.245 and a default mask of 255.255. 255.0.
How do I reset my Cisco Aironet 1200 to factory settings?
Factory Reset via MODE Button Press and hold the MODE button while you reconnect power to the access point. Hold the MODE button until the Status LED turns amber (approximately 1 to 2 seconds), and release the button.
How do I setup a router as an access point?
Simply connect the access point to one of the ports of your existing wired/wireless router then configure the access point’s wireless settings.
- Open the access point’s web-based setup page by entering the default IP Address “192.168.
- On the web-based setup page, click on Wireless.
- Enter the Network Name (SSID).
What does the Cisco Aironet 1100 series access point do?
The 1100 series access point uses a single mini-PCI radio that can be upgraded to future radio technologies such as 802.11g. The access point serves as the connection point between wireless and wired networks or as the center point of a stand-alone wireless network.
Is the CAPWAP controller compatible with Cisco Aironet?
The discovery process using CAPWAP is identical to the Lightweight Access Point Protocol (LWAPP) used with previous Cisco Aironet access points. LWAPP-enabled access points are compatible with CAPWAP, and conversion to a CAPWAP controller is seamless.
How to configure Cisco Aironet with internet browser?
Step 1 Open your Internet browser. The wireless device web-browser interface is fully compatible with Microsoft Internet Explorer version 9.0 and Mozilla Firefox version 17. Step 2 Enter the wireless device IP address in the browser address line and press Enter. An Enter Network Password window appears.
Is there CAPWAP support for Cisco 1100 series?
CAPWAP support is provided in controller software release 8.5 or later. However, your controller must be running the release that supports Cisco 1100 Series access points. You cannot edit or query any access point using the controller CLI if the name of the access point contains a space. Make sure that the controller is set to the current time.