How do you reset the airbag light on a 2001 Honda Accord?
How do you reset the SRS light on a 2001 Honda Accord?
- Verify and make sure the ignition is switched OFF.
- Connect the 2 pins in the MES with a paper clip or metal object.
- Turn the ignition switch ON.
- The SRS Indicator Light should come on for 6 seconds and then go off.
- The SRS Indicator Light should come back on agian.
How do you turn off the airbag light?
The first step is to turn the ignition switch on, which will make the airbag light to come on. The light will flash for exactly seven seconds. Once it is off, you have to turn off the ignition within a second. Turn the ignition on again after three seconds.
What causes Honda Accord airbag light to go off?
The failure and the current mileage was 36,000. The consumer also stated the tpms light illuminated. When she took the vehicle to the dealer, it went off and then came back on. The dealer stated by plugging in her cell phone, it was causing the light tpms light to illuminate.
How do you replace ignition switch on Honda Accord?
Route the wiring in the same manner the old switch wiring was routed, insert the switch into the steering column, and put back the ignition switch cover and screws. Use the electrical tape to corral any of the loose wiring. Put all paneling back the way it was by following the above directions in reverse.
How long does the airbag light stay on?
To start the process get your watch ready and turn the ignition switch from “Off” to “On.” Once the airbag light comes on it will stay on for a total of seven seconds. Once it turns off, you will have a second to turn the ignition back to “Off.” After you have the ignition off for three seconds, you will need to turn the key back “On.”
The first step is to turn the ignition switch on, which will make the airbag light to come on. The light will flash for exactly seven seconds. Once it is off, you have to turn off the ignition within a second. Turn the ignition on again after three seconds.
Where is the ignition switch on a Honda Accord?
Begin on the left side and gently pull it off, so that all of the retaining clips are released. The ignition switch can now be unplugged for testing. The switch connects to the rear of the driver’s side fuse panel. Shine a flashlight and find the connector highlighted in red.
What does it mean when your airbag light is on?
All the same, the most important thing to know is that, an illuminated airbag light indicates a problem in the SRS system. This means that airbags might not deploy in the event of an accident. Here are the common reasons that cause your airbag light to illuminate; 1. Airbag Clock Spring Damage
How can I tell if my airbag sensor is working?
To determine if the sensor is working okay, first check the “Passenger Airbag Off” indicator. If the seat is vacant, this light should be on. When the seat is occupied it should turn off implying that the airbag system is online and functioning. If the light is off when the seat is vacant or vice-versa, there could be a problem with the sensor.