Why will my Craftsman mower not go forward or reverse?
Sounds like the brake may have stuck. It’s on the side of the transmission. Could also be that the belt jumped off a pulley and got stuck under it.
Why is my craftsman riding mower running rough?
If your riding mower’s e engine runs rough or misfires, the carburetor could be clogged.. Rebuild or replace the carburetor if it’s clogged. If the engine runs rough after hitting a rock or stump, check the flywheel key-a damaged flywheel key will disrupt the ignition timing.
How do you adjust the reverse on a Craftsman lawn tractor?
Move motion control lever to full forward position and hold for five (5) seconds. Move lever to full reverse position and hold for five (5) seconds. Repeat this procedure three (3) times.
What causes a hydrostatic transmission to slip?
By far, the most common reason for hydrostatic transmission failure is old hydraulic fluid. John Deere states that “Operating outside of the recommended oil air temperature range may cause premature hydrostatic transmission failure.” Oil must be changed when its anti-foam additive decays.
What causes a lawn mower engine to run rough?
A clogged or dirty carburetor causes the engine to run rough or prevents the engine from starting. If you can start the engine using starter fluid but the engine won’t continue to run, clogged carburetor jets may be the problem.
Why does my lawn mower not run smoothly?
A dirty air filter is one of the most common causes of a poorly running lawn mower, since it starves the engine of the oxygen needed for combustion. Fuel Filter: Check the fuel filter on the mower to make sure it’s clean, and replace it if needed.
What could cause a craftsman lawn mower to not start?
Check for any leaks under the Craftsman push mower. Any leaking from the lines indicates a line problem.
How do you start a craftsman electric mower?
If you are starting your Craftsman 5 hp mower for the first time, be aware that the company ships the mower without engine oil. Park the mower on a flat surface without tall grass. Open the oil fill port, remove the dipstick and check the oil level. Open the gasoline tank and make sure the mower has fuel.
What causes engine on Craftsman riding mower to backfire?
A backfire can be caused by events such as shutting down the engine too quickly or rising up on the seat and activating a safety switch. When the mower’s backfiring is accompanied by a degradation of power, the cause requires deeper troubleshooting.
How do I drain the gas from my Craftsman lawn mower?
Drain the oil and gas mixture from the gas tank. Either tip the lawn mower on its side and drain the mixture into an approved container, or siphon the mixture into an approved container using a siphon hose. Refill the oil reservoir to the appropriate level as determined by your lawn mower’s operation manual. Refill the gas tank with new gas.