Why is my ice maker not working but water does?
If the water inlet valve is defective, or if it has insufficient pressure, it won’t allow water to flow through. As a result, the ice maker won’t make ice. The valve requires at least 20 psi to function properly. Make sure that the water pressure to the valve is at least 20 psi.
What causes a ice maker to stop working?
Cause: A common cause for a clog is frozen water in the line. Cause: There is also a possibility that the water filter for the ice maker is clogged. Fix: Locate and replace the water filter. Filters for ice makers are typically located inside the refrigerator (to keep them from freezing).
Why is there no ice coming out of my fridge?
Cause: A common cause for a clog is frozen water in the line. Fix: To repair a frozen line, slide the refrigerator and unplug it. Cause: There is also a possibility that the water filter for the ice maker is clogged. Fix: Locate and replace the water filter.
How do I get my ice maker to dispense ice?
Typically an ice dispenser uses an auger to get the ice cubes out, but if there are no separate cubes or chunks that can be broken apart by the auger, you will get no ice. Pull out your ice maker and check for clumps near the bottom of the bin or even inside the dispenser itself that will prevent dispensation.
How do you jumpstart a Kenmore ice maker?
You should notice two tiny holes labeled “T” and “H,” and this is where you should insert each end of your wire. After a few seconds of holding the wire in the designated holes (and only these holes), you should hear the desired click, which means you have successfully jump started your ice maker.
Why is there an error code on my Kenmore 795?
Error codes for Kenmore 795 and Kenmore Elite 795 refrigerators result from component failures and appear on the temperature display. The refrigerator stops cooling when some Kenmore refrigerator error codes are displayed.
Why is my Kenmore Elite ice maker not working?
Watch the icemaker cycle and if water does fill at the end of the cycle and since the icemaker has been replaced, it will indicate a thermistor (sensor) problem or the icemaker compartment is not getting cold enough. Most of the time it will be a sensor problem and the sensor # 6500JB1008A will need to be replaced.
Why is there an error code on my Kenmore refrigerator?
These explanations can help troubleshoot problems that result in error codes for Kenmore Elite 795 refrigerators and Kenmore 795 refrigerators with bottom freezers. Error codes for Kenmore 795 and Kenmore Elite 795 refrigerators result from component failures and appear on the temperature display.
What should I do if my ice maker is not working?
If none of these parts are at fault, and the freezer temperature is at least 15 degrees Fahrenheit, replace the ice maker assembly. The icemaker module is equipped with a motor that cycles the ice ejector arms or turns a tray to eject the cubes into the ice bucket.