Why does my element car start intermittently?
Starting about 4 months I couldn’t get the key into the ignition off and on. Then about 2 months ago, the car wouldn’t start intermittently. Or if it did there was a slight hesitation before it connected. On Nov. 11 I had the battery replaced after it tested “bad” but the starter apparently was ok.
How much does a Honda Element ignition cost?
The complete ignition lock and switch assembly is part # 35100-S9A-A-53. Majestic Honda has it listed at $338.71. It can be found on ebay for $285.00. It should take no more than two hours labor time for replacement.
When to jump solenoid on element intermittent starting problems?
When you turn the key to the on position (dash light system check etc but not to crank position) do you hear the fuel pump whrrr.. every time, even when it won’t crank? Click to expand… I had to laught at the flowchart where it said to jump the solenoid on the starter….
How to diagnose an element intermittent starting problem?
Click to expand… It is impossible to diagnose a starting problem that is not present at the time of testing, especially by long distance. However, the difficulty in inserting the ignition key points to a lock cylinder worn and the hesitation when attempting to start could be the electrical portion of the ignition switch.
What to do if your ignition cylinder is worn out?
How To Fix It: Fortunately, this is an easy fix. Just turn the wheel back and forth until the ignition cylinder is freed. It’s a fact of life that mechanical things tend to wear out, and the same goes for mechanical keys and key cylinders used in your car’s ignition system.
How often should you insert and remove the ignition key?
You may insert and remove the ignition key thousands of times every year, wearing the key and tumblers ever-so-slightly every time. Heavy keychains can add more stress to the ignition cylinder, increasing wear. After a while, the key may fall out of the cylinder or be unable to turn out of the lock position.
What happens if you have an incorrect ignition code?
The chip in the key transmits a specific code, of which there are millions. If this code matches the ones programmed into the vehicle, engine starting is enabled. An incorrect key code, such as from an unprogrammed key or damaged key, would prevent engine starting. Code “confusion,” such as having multiple keys can also occur, preventing ignition.
Can a unworn key turn an ignition cylinder?
Or, an unworn key may not turn a worn ignition cylinder, as they haven’t “worn together.” How To Fix It: The best way to do this is to get a new lockset, with new keys and a new cylinder. You might consider getting a matched lockset that includes the door and trunk cylinders.