Where is the negative terminal on a Honda Pilot battery?
It is placed under the air intake. You have to take the front engine cover off (pop rivets) and the air intake off (plastic screws) just to get to the negative terminal.
How do you jumpstart a Honda Fit?
Honda Fit: Jump Starting
- Connect the first jumper cable to your vehicle’s battery + terminal.
- Connect the other end of the first jumper cable to the assisting vehicle’s + terminal.
- Connect the second jumper cable to the assisting vehicle’s – terminal.
What happens when you change the alternator on a Honda Pilot?
The battery failed internally in such a way that would duplicate removing the battery while the vehicle was running. This spikes the charging system and blows the regulator. When it does this it shorts the charging system creating a large draw. After some searching on the web I found lots of bad ways to do this job so I will show you how I did it.
How do I loosen the bolts on my alternator?
Loosen the bolts on the alternator if there is no auto-tensioner. In cars without an auto-tensioner pulley, you can relieve the tension on the belt simply by loosening the two bolts that secure the alternator to the engine. These will often require a 14mm or 1⁄2 inch (1.3 cm) socket, though you may need to try others.
How do you install a new alternator in a car?
Installing the New Alternator Slide the new alternator into place. You might have to wiggle the alternator around to squeeze it back into place in a crowded engine bay. Insert the mounting bolts. Slide the mounting bolts through the alternator and into the mounting bracket. Run the belt over the new alternator pulley.
Do you need to remove serpentine belt to change alternator?
As you loosen the bolts, the alternator will slide in the bracket under the tension of the belt. You may not need to remove the serpentine or accessory belt if it’s not damaged.
The battery failed internally in such a way that would duplicate removing the battery while the vehicle was running. This spikes the charging system and blows the regulator. When it does this it shorts the charging system creating a large draw. After some searching on the web I found lots of bad ways to do this job so I will show you how I did it.
How do you remove power steering from Honda Pilot?
To remove the power steering reservoir you need to free the latch from the stand it is on. To do this gently pry the tab at the top of the stand and then put your hand under the reservoir and lift straight up. If it fights, rinse and repeat on this step until the reservoir is free. Remove the cap from the reservoir.
What should the voltage be on Honda alternator?
If the alternator is functioning properly, the voltage displayed on the meter will be around 13.5 volts. If the voltage displayed is the same or less than battery voltage, replace the alternator. Lee Sallings is a freelance writer from Fort Worth, Texas.
Where to test battery voltage at alternator?
Test for battery voltage at the alternator on the charging lug located on the back of the alternator. The charging lug will have a large gauge wire, covered by a rubber boot, bolted to it that supplies power to the rest of the vehicle when the engine is running.