What are the specs of a Honda B16?
Bore: 81mm; Stroke: 77.4mm; Deck: Open Deck; Compression Ratio: 10.2:1 to 10.8:1; Horsepower: 150 horsepower up to 187 horsepower; Torque: 110 lb-ft up to 118 lb-ft; Honda B16: Vehicles. The B16 came in a host of different vehicles ranging from Civic, CRX, Del Sol, and Integra.
What are the valve clearances on a Honda B16A?
If the timing belt breaks, the engine will bend valves, however, this may not happen at low RPM. Valve clearances should be checked after every 24,000 miles of mileage, and adjusted, if necessary. Valve clearances (cold): intake 0.15-0.19 mm, exhaust 0.17-0.21 mm. The firing order for B16A and B16B was 1-3-4-2.
What kind of exhaust system does a B16A have?
You just have to regularly and with good quality perform maintenance of your B16A or B16B, and they will run a bit longer. The best mods for a regular B16A are a cold air intake system, B18C 98 Spec R 4-1 exhaust manifold (or another 4-1 manifold) and a 2.5 exhaust system. This will give you up to 180 HP.
How often does a Honda B16A engine need to be replaced?
The engine block is covered with the DOHC VTEC head. This was the first Honda engine with a VTEC system. Camshafts were rotated by the timing belt to be replaced after every 60,000 miles (100,000 km) of travel. If the timing belt breaks, the engine will bend valves, however, this may not happen at low RPM.
What makes a Honda B16 have so much horsepower?
Honda was able to achieve such great horsepower per liter by utilizing their VTEC technology, as well as having very high rev limiters ( (RPM*Torque)/5252 = Horsepower). With an engine that revs to 9k RPM, achieving high horsepower numbers isn’t too hard, assuming parts like the camshaft are designed for it.
If the timing belt breaks, the engine will bend valves, however, this may not happen at low RPM. Valve clearances should be checked after every 24,000 miles of mileage, and adjusted, if necessary. Valve clearances (cold): intake 0.15-0.19 mm, exhaust 0.17-0.21 mm. The firing order for B16A and B16B was 1-3-4-2.
What are the specs of a Honda Civic B16A?
Here are cam specs of SiR B16A: duration (at .050″ or 1 mm lift) 230/227 deg, lift 10.6/9.4 mm. The power was 160 HP @ 7,600 rpm, torque was 150 Nm @ 7,000 rpm, and the redline was at 8,000 rpm. This engine was installed in Honda Civic SiR, CRX SiR and Integra. 2. B16A SiR 2 gen. is the Japanese version of B16A SiR.
You just have to regularly and with good quality perform maintenance of your B16A or B16B, and they will run a bit longer. The best mods for a regular B16A are a cold air intake system, B18C 98 Spec R 4-1 exhaust manifold (or another 4-1 manifold) and a 2.5 exhaust system. This will give you up to 180 HP.