How do I get my Honda CRV out of valet mode?
Press and release the foot brake pedal 10 times within 10 seconds. If you see/hear two parking light flashes/clicks, you have exited valet mode. Remove the key from the ignition and attempt to remote start your vehicle.
Where do you put the valet key on a Honda?
Your vehicle comes with two master keys and a valet key. When replacing keys, use only Honda-approved key blanks. The valet key works only in the ignition and the door locks. You can keep the glove box and hatch locked when you leave your vehicle and the valet key at a parking facility. Youshouldhavereceivedakey number tag with your set of keys.
How to put a Honda Accord in valet mode?
Insert the ignition key, and remove the ignition key from the ignition switch. (All the way out) Insert the ignition key. The Status LED will flash once, indicating that the system is in the Valet mode. 0 within 3 seconds 4Status LED 4713010M 4713010M 8© 2004 American Honda Motor Co., Inc. – All Rights Reserved. Valet (Auto Arming Mode only)
How to turn valet mode on and off?
Insert the ignition key, and remove the iginition key from the iginition switch. (All the way out.) Insert the ignition key, and remove the ignition key from the ignition switch. (All the way out) Insert the ignition key. The Status LED will flash once, indicating that the system is in the Valet mode. 0 within 3 seconds 4Status LED
What do you need to know about valet keys?
KEY MASTER VALET KEYS KEY These keys contain electronic circuits that are activated by the Immobilizer System. They will not work to start the engine if the circuits are damaged. Protect the keys from direct sunlight, high temperature, and high humidity. The keys do not contain batteries. Do not try to take them apart.
How do I put my car in valet mode?
Insert your vehicle’s key into the ignition and turn to the “ON/RUN” position. Do not crank the engine. Press and release the LOCK and TRUNK buttons (I & III) simultaneously. Do not hold the buttons down, a quick press will be enough. Remove the key from the ignition and attempt to remote start your vehicle.
How do I put my Honda CRV in accessory mode?
On my mdx, I can go to accessory mode by turning off the engine while holding the shift knob’s release button while not stepping on the brake. On page 172 of the manual.
What does valet mode do on a Compustar?
What is “Valet Mode”? Valet mode is a setting in Compustar and Arctic Start systems that will shut down the alarm system and the remote starter. It will only allow the remotes to retain key-less entry to be used to lock and unlock the doors.
What happens if I put my alarm in valet mode?
Check the LED light on your alarm system while continuing to press the button. If the valet mode activation is successful, this light will remain solid.