How do you unlock a Creda heater?
To unlock repeat the action by pressing both the Back button and Enter for three seconds. The controls are located on the top of the heater.
Why is my storage heater flashing red?
The display screen may flash red to indicate the product has overheated. To reset the display, remove the obstruction and hold Enter for 10 seconds. WARNING- This heater is suitable for normal domestic household purposes and should not be used in any other type of environment.
Do storage heaters have a fuse?
Storage heaters should have their own fuse or circuit breaker at the fuse box or consumer unit. These are normally rated at 16 Amps or on older wire fuses in a blue coloured fuse holder at 15 Amps. Its already protected at the fuse box.
Why is my storage heater not heating up?
If your storage heater stops working, there are two most common possibilities – a faulty thermostat and a broken element, provided that it was not covered by clothing accidentally. By performing a thermostat manual reset, it is possible to repair your storage heater. Turn off the power supply and remove it.
Why is my electric heater not working?
CAUSE: The most common cause for electric heater not working is blown fuses. If it is fuses or tripped, then what you can do is that you can replace the fuse or reset the circuit breakers if required. Now plug the appliance back in and switch it on. See if the problem has been resolved.
How do you reset a panel heater?
The display is flashing or staying red -If the heater is obstructed by furniture, for example, then please move the obstruction and switch it off at the wall for 15 minutes before turning it back on. This should reset the panel heater and the fault should have cleared.
Why has my storage heater stopped working?
Why is my storage heater blowing out cold air?
An electric heater that blows cold air could be caused by one or more of the following reasons: The manual reset has tripped. The fan switch is “on” and the thermostat setting is below the actual temperature. The fan is dispersing this air after shutdown.
How do you reset a Noirot heater?
To reset the thermal cut-out, simply switch the heater off, unplug it from the power point and remove the obstruction(s). Plug the heater back in and switch it on. The thermal cut-out switch will reset after a few minutes and the heater will function normally. touched by a person in the bath or shower.
Where is the model code on a Creda panel heater?
The product model code can usually be found on the side of the product. The cable entry point for this panel heater will be found on the rear of the product, in the bottom right hand corner.
What should I do if my storage heater is not working?
Switch off the 24-hour supply for 10 seconds to factory reset your storage heater. -If this does not resolve the issue, we need to check what temperature the heat is set to in the evening on your heater.
How to adjust the temperature of a storage heater?
-First, check what the temperature is set to by pressing the round dial once and looking at what temperature is displayed on the screen. -Set the temperature to maximum – Max (26) – and leave it to charge overnight. Gradually adjust this over next few days until the desired temperature is reached.
Can a storage heater be set to master mode?
-If there is another storage heater in close proximity, set the heaters to master/slave mode. The nearby heater may have caused it to turn off prematurely. Please refer to the instructions on how to set the storage heater into master and slave mode.