How can I reset the SRS light on my car?
Another method that some people have used is to reset the SRS light by turning the electrical on and off in a sequence. To do this, turn the key in the ignition, but do not start the car. Just turn it far enough to turn on the electrical.
Why does my SRS light keep coming on?
I have a 2000 ML320. SRS light came on one day. After researching what everone said, I decided to inspect the airbag on my steering wheel. This was a mistake because you cannot disconnect the wire harness from the column to the airbag to check for faulty wiring. You can unplug the wire from the airbag, by carefully pulling the plug.
Where is the SRS light on a Mercedes Benz?
This is located on the lower left side of the control panel on the driver’s side of the car. Find the port that fits the OBD cable and plug the scan tool’s cable into this port. 2. Put the key into the ignition and turn it to the “Run” position. This is the position just before the engine starts.
What does the SRS light on the dash mean?
It then sends the information to the Airbag Control Unit, which figures out which seatbelts to tighten and which airbags to activate. When lit up on your dash, the SRS light resembles the side view of a buckled-up person with an airbag in front of them. In some vehicles, the letters “SRS” will be illuminated too.
Is there a way to reset the SRS light?
You can’t rest the airbag SRS light with a simple OBD II scanner which gives you the check engine light codes. You will need a more advanced scan tool to reset the airbag light. For around $110-150, which is how much a diagnosis costs anyway, you can get your airbag reset tool.
Why does the SRS warning light come on?
SRS light is on. There are a few reasons why the SRS light turns on. One of the most common reasons the airbag light turns on is because there is an interference happening with the seat belt and the sensor. This causes the warning light to falsely come on. The next reason the SRS light might be on has to do with the passenger’s seat.
When does the SRS airbag light come on?
The airbag light will be blinking for seconds after the ignition if there is any trouble. This system is working to check the airbags for drivers, passengers and sides airbags, including the modulator, inflation, and wiring.
Is there a scanner that reads the SRS light?
Here is a scanner that works with Mercedes-Benz and will rear fault codes and reset the AirBag, ABS and check engine light. Our favorite scanner that for an in-depth Mercedes-Benz troubleshooting is the iCarsoft MB II. Not only does it read the SRS light (Airbag Control Unit) but also every control unit in your Mercedes-Benz.