How can I make my Raptor 50 faster?
Remove all of the air cleaner assembly and install K&N air filter with outerwear. Replace CDI box with any aftermarket unit that raises the electronic rev limiter. Replace stock size rims/tires with larger rims/tires for more top end and smaller tires/rims for more low end.
How do you adjust the carburetor on a Yamaha Raptor 50?
Turn the pilot screw clockwise a quarter turn at a time until the engine idle speed increases. If the engine idle speed does not increase, reset the pilot screw, then turn the screw counterclockwise until the engine idle speed increases. Do not turn the screw more than three counterclockwise turns.
What is the fastest Yamaha Raptor?
Yamaha Raptor 700R People love the aggressive look the raptor 700 has, and a lot of enthusiast modify these quads to go even faster. In fact, the Guinness world record for fastest land speed on an ATV was with a modified Raptor 700.
What years did Yamaha make the Raptor 50?
YAMAHA Raptor 50 2006 – Present.
How fast is a 50cc 4 wheeler?
A 50cc ATV that has 4 gears can easily travel at over 30 mph and it takes physical strength to control an ATV at those speeds.
How do you adjust the idle on a Raptor 90?
You can only adjust the idle screw, air/fuel mixture screw and add a washer to the needle. The air/fuel mixture screw is about 2 1/2 to 2 3/4 turns out. You turn it out until your rpm lower then turn it in until they rise then lower again, then turn it back out until you get your highest rpms.
How to change the speed of a raptor?
Replace the slide with part# 2HX-14112-35-00 also need to replace main nozzle with part# 2HX-14141-78-00. Remove the two screws on throttle housing, you will see a gold bracket you need to replace with part# 36B-2625H-00.
How to adjust the pilot screw on a Yamaha Raptor 50?
Count the number of turns it took to seat the screw and write it down in your Raptor 50’s owner’s manual for future reference; this is the factory pilot screw setting. Turn the pilot screw counterclockwise the same number of turns needed to seat the screw.
Can a raptor 50 hit 30mph modded?
With a combo of these mods its been said you can make a Raptor 50 hit 30mph and beat a stock Raptor 80 or 90. These are all basically Raptor 80 parts being put on the 50. Been there done that. It does help but is it still a pooch. What did you expect from a 50?
How does the carburetor work on a raptor 50?
by Chris Gilliland. The carburetor used by Yamaha’s Raptor 50 all-terrain vehicle relies on a constant flow of air to draw fuel into the engine. An adjustable pilot screw controls the carburetor’s pilot system, which feeds the engine from idle to a quarter throttle through a single fuel jet housed under the carburetor.