What should I do if my Honda Accord has no power?
Ok light should come on just for few seconds and go off. And the voltage drop you are seeing is probably normal with the starter turning over at same time. And you have pulled one of your plugs wires off and checked for spark using and old plug or timing light. 2 people found this helpful.
Where is the trouble code located on a Honda Accord?
Insert the jumper wire in the 2 PIN service connector between pins 1 and 2. You should also see a 3 PIN connector. This is used for a trouble code scanner. Trouble codes will be stored in the ECU even if the check engine light is not on.
Where is the OBD plug on a 1991 Honda Accord?
The connector may be blue or yellow in color. If the connector has not been used before, you may find it still taped or strapped to the main wiring harness going to the ECU (engine control unit). Insert the jumper wire in the 2 PIN service connector between pins 1 and 2.
Why does my Honda Accord LX not start?
I have a 1991 Honda Accord lx that turns over cranks but does not start.. the distributor is not getting spark. The whole dizzy is new,ecu new spark plugs new, wires new main relay new the CEL turns on when the key is on the ON position and it shuts off.. 1 people found this helpful. having same problem here.
Insert the jumper wire in the 2 PIN service connector between pins 1 and 2. You should also see a 3 PIN connector. This is used for a trouble code scanner. Trouble codes will be stored in the ECU even if the check engine light is not on.
The connector may be blue or yellow in color. If the connector has not been used before, you may find it still taped or strapped to the main wiring harness going to the ECU (engine control unit). Insert the jumper wire in the 2 PIN service connector between pins 1 and 2.
Why does my freeze plug crack on my car?
In the case of the water jacket in your engine block, this is more than enough pressure to cause it to crack destroying your engine. The engine in your vehicle also has a secondary line of defense against freeze damage, freeze plugs. Freeze plugs are usually aluminum or brass plugs pressed…
What should I do if my freeze plug is leaking?
When a leaking freeze plug is found, the engine should be checked for damage and antifreeze checked for the proper mixture and freezing point. However, freeze plugs can also start to leak over time simply due to the heating and cooling cycles of driving your car.
Ok light should come on just for few seconds and go off. And the voltage drop you are seeing is probably normal with the starter turning over at same time. And you have pulled one of your plugs wires off and checked for spark using and old plug or timing light. 2 people found this helpful.
I have a 1991 Honda Accord lx that turns over cranks but does not start.. the distributor is not getting spark. The whole dizzy is new,ecu new spark plugs new, wires new main relay new the CEL turns on when the key is on the ON position and it shuts off.. 1 people found this helpful. having same problem here.
Is there a problem with my Honda Accord EX?
Here is what this owner experienced: My 1991 Honda Accord EX has 178,000 miles with little or no problem until now. Driving home the other night it just shut off as though I turned the car off. No sputter no nothing. It cranks and cranks but would not and will not start.
What should ignition resistance be on Honda Accord?
To check the ignition coil, measure the resistance between the + terminal (black/yellow wire) and the – terminal (white/blue wire) of the coil. The resistance should be about 0.6 to 0.8 ohms at 70° F. Then check the resistance between the + terminal (black/yellow wire) and the coil wire terminal. It should be about 12,000 to 19,200 ohms at 70° F.
What happens when the ignition coil goes bad on a Honda Accord?
The most common symptom that your Honda Accord or Prelude will experience when the igniter (ignition control module) or the ignition coil goes bad, will be a NO START. In some cases the igniter fails intermittently causing your car to start and run most of the time and not start some of the time.
How does the ECU work on a Honda Accord?
The whole dizzy is new,ecu new spark plugs new, wires new main relay new the CEL turns on when the key is on the ON position and it shuts off.. 1 people found this helpful. having same problem here. After an engine swap waiting on a harness adapter. To see if itll be ecu. Anyone found a solution yet would be very helpful
What happens if there is no power to the distributor?
Cause car will do other functions with out ecu powered up. It just won’t run. Most will turn over and act like they are trying to start but won’t if no power to ecu. 4 people found this helpful.
What is the fuse box diagram for a Honda Accord?
Driver’s Power Seat Motor (Driver’s Power Seat Front Up-Down Motor, Driver’s Power Seat Slide Motor) Integrated Control Unit, Power Antenna Motor, Trunk Light, Courtesy Lights, Ceiling Light, Map Lights Engine/Powertrain Control Module (ECM/PCM), Clock, Stereo Radio/Cassette Player, Transmission Control Module (TCM)
The whole dizzy is new,ecu new spark plugs new, wires new main relay new the CEL turns on when the key is on the ON position and it shuts off.. 1 people found this helpful. having same problem here. After an engine swap waiting on a harness adapter. To see if itll be ecu. Anyone found a solution yet would be very helpful
Where is the first cylinder on a Honda Accord?
An important thing to understand when finding the location of cylinder one is that it’s going to be the first cylinder in the firing order of the vehicle, and not the first cylinder that you might see when looking at the engine. The P0301 Honda trouble code will trigger the Accord’s service engine soon light.
Why does my Honda Accord DX have no AC?
This is a 99 honda accord dx, 102,000 miles. helpful? The ac dash controls don’t seem to work. The blower comes on but no ac or lights. The dealer says I just need a new panel. He also says that the reason the car overheated is because of the ac dash controls failing.
What is the misfire code on a Honda Accord?
Honda Accord P0301 Definition P0301 is a cylinder specific misfire code, which means that cylinder 1 is misfiring and causing the code.
Why is the AC not working on my Honda Accord?
> I have a Honda Accord 1999 EX Model. I face a strange problem. When i > turn on. I try pushing mode button, temprature knowb, a/c button > not turn on. It seems as if there is no power in the panel. However, > The radio and cd player below it works fine. > dramatically turn on and everything starts working great.
An important thing to understand when finding the location of cylinder one is that it’s going to be the first cylinder in the firing order of the vehicle, and not the first cylinder that you might see when looking at the engine. The P0301 Honda trouble code will trigger the Accord’s service engine soon light.
Honda Accord P0301 Definition P0301 is a cylinder specific misfire code, which means that cylinder 1 is misfiring and causing the code.
What does the code p0301 mean on a Honda Accord?
P0301 is a very common OBDII trouble code that appears in the Honda Accord. It stands for: P0301 should be considered a cause for concern, and can be a threat to the drivability the Honda Accord. The one nice thing about P0301 is that it is a cylinder specific misfire code.
How is the gas pressure regulated in a Honda Accord?
That pump gives off a constant pressure and that pressure is then regulated to the fuel delivery rail by allowing some of the pressure to bleed off back to the gas tank on a return line via the fuel pressure regulator.
Why do I lose acceleration on my Honda Accord?
I have a 92 Honda accord EX the fuel pump was replaced 02 upstream replaced and when I push on the gas I lose acceleration as well mechanic checked the pressure said it was fine but than there is so much pressure in my fuel that every time I pop the gas cap so much air comes out n than it runs fine for a little bit idk what else to check for.
Where is the fuel pressure regulator on a Honda Accord?
The fuel pressure regulator is an easy replacement if it’s bad. The fuel rail on your car is a shiny aluminum stick that runs along the back side of the engine between the engine and firewall. The fuel pressure regulator is located on the drivers side of that rail. You also may want to have a dealer run fault codes on the car.