How do you rebuild a Volkswagen Jetta turbocharger?
As you loosen the bolts, you can rotate the triangular tabs out of the way and lift the center section out of the turbine housing. These six bolts will be replaced. The next step is to separate the compressor housing from the center section. Opposite the two bolts that secured the wastegate are two more 10mm bolts that you must remove.
What was the problem with my VW Jetta?
The car started to shake and started to move slowly down the road. I barely got it to the shop. At the shop they said cylinder four was not firing correctly. The engine was putting to much fuel into the cylinder making the cylinder fire to frequently. They still dont know what’s wrong. 1 people found this helpful.
Why does my Volkswagen Jetta battery keep draining?
It died about 10 weeks ago and the battery started draining 6 weeks after that. I’ve read that dead radios can drain the battery. So I had a new radio installed by Car Toys, but the problem did not stop. The mechanics said they found nothing with the radio that would be draining my battery. I’ve tried locking the car at night. I’ve been over
How old is the battery on my VW Jetta?
It was my 1999 Mercedes SL 500>.Mileage is 62,000.The batter is one year old,,So my honey took the batter back to auto part store and Thankfully they r replaced it,,You usually get a 3 yr warranty with new Batteries ,,BUT always Check before you purchase..Thanks to All for Your HELP..ox 5 people found this helpful.
Can a gasket be removed from a turbocharger?
With the two bolts removed, the tube can be disconnected from the turbo. You should have a small drip of oil, but not much more than that. This gasket, which sits between the oil drain tube and the turbocharger, should be replaced during the reassembly process.
How many bolts are in a Volkswagen turbo?
Six 10mm bolts hold the turbine section to the center section of the turbo. Some of these bolts are easy to reach, and some are not. In addition, some of the bolts basically have to be removed as you separate the two sections from each other because access to them is limited.
How do you replace wastegate on Volkswagen Golf?
First step is to remove the wastegate actuator. Loosen the 10mm nut that secures the wastegate actuator rod to the lever arm that moves the wastegate inside the turbine housing. Leave the remaining nut in place on the actuator rod. This will ensure that you can replace the rod in the same position later.