Where is the VW fault code located on a Passat B3?
Since April 1989, the Passat B3 has been equipped with a two-pin connector located under the cover below the climate control unit. On later machines, the connector began to be placed at the feet of the driver or passenger sitting in front. To read the VW error codes on machines with a single, double, or triple connector, you must:
What does the VW Passat fault warning light mean?
Warning light name: VW Passat lights fault warning light. Description: This warning light comes on due to a fault in the vehicle lighting. Check all lights and change bulb if required. This may also indicate a fault in the dynamic cornering light. Warning light name: VW Passat check engine warning light.
What causes a fault code 01316 on a VW?
A solution to the problem can be an adaptation of the sensor and checking the camber / convergence of the front wheels. The failure of at least one sensor on the wheels causes a common error in the ABS / CAP system with code 01316. Such a problem can occur on any machine with an anti-lock system, including the Touareg.
What does fault code p0016 mean on VW?
Very often, the problem lies in the oxidation and cracking of the tracks, which are fed by signals from the pedal and the control unit of the ENP system. After repairs related to disassembling the timing drive, an error P0016 or simply 0016 may occur, which means the relative position of the engine shafts is incorrect.
What does the code 01316 mean on a VW?
The failure of at least one sensor on the wheels causes a common error in the ABS / CAP system with code 01316. Such a problem can occur on any machine with an anti-lock system, including the Touareg.
What does the code 00772 mean on a VW Turan?
Errors with the code 00772 denote the failure of the oil pressure sensor or its wiring and can occur on any gasoline engines and diesel engines installed, for example, on Tiguane or Turan. Diesel Touareg with large runs often have an error P2002, indicating the wear of the diesel particulate filter of one of the cylinder blocks.
What does code P2006 on OBD II mean?
Although generic, the specific repair steps may vary depending on make/model. If your OBD II equipped vehicle has stored a code P2006, it means that the powertrain control module (PCM) has detected that the intake manifold air control (IMRC) actuator for engine bank one is stuck in the closed position.