What happens if you put a serpentine belt on backwards?
If you put the belt back on in the opposite direction, the ribs end up in different pulley grooves than the ones they’ve adapted to over time. This means that the belt has to re-adjust to a new abrasion pattern, which will lead to a dangerous loss of belt tension.
How much is it to get a serpentine belt put back on?
Serpentine Belt Replacement Cost It is very inexpensive to replace a serpentine belt whether it’s broken or loose. The replacement cost is only going to be between $100 and $200 in most cases. The belt itself will cost between $25 and $80 while the labor costs will probably be between $75 and $120.
Is it possible to put a serpentine belt on wrong?
NOTE: A serpentine belt will usually go on only one way. In some instances it may be possible to install a serpentine belt the wrong way. If this happens, one or more pulleys will rotate in the WRONG direction, affecting the operation of the alternator, water pump, A/C compressor or power steering pump.
What is the serpentine belt on a VW?
The serpentine belt or v-ribbed belt on a Volkswagen is a flat belt that powers the engine accessories, such as the air conditioning compressor and alternator. Removal of this belt can be accomplished by the vehicle owner, as it requires no special tools.
How do you replace a V-belt on a VW?
Check that the v-belt is properly seated into the engine pulleys. Pull the power steering pump away from the engine and tighten the mounting bolts using a socket. Place a straight edge over the two pulleys at the v-belt’s longest run. Press down at the midpoint of the belt with your finger.
How do you remove a serpentine belt from an alternator?
Instructions 1. Remove the engine cover 2. Move the cooling line completely out of the way. To do this, release the plastic retention tab and lift the line up and over. 3. To remove the serpentine belt, release tension off of the tensioner. Then grab the serpentine belt between the a/c compressor and alternator just pull it off. 4. Caution!
What’s the best way to tighten a V-belt?
Place a straight edge over the two pulleys at the v-belt’s longest run. Press down at the midpoint of the belt with your finger. Measure the distance between the straight edge and the belt with a ruler. The distance should be less that 13/64-inch. Tighten the v-belt by loosening the power steering pump mounting bolts, using a socket.