What kind of oil does a 2013 Jetta SE take?
The type of oil that is recommended for the 2013 Volkswagen Jetta is SAE 5W-40 MS Synthetic for the 2.0 L 4Cylinder and the 2.5 L 5-cylinder and SAE 5W-30 LS Synthetic for the 2.0 L 4Cylinder diesel engine.
What kind of oil does a Volkswagen Jetta 2.5 SE take?
Your VW Jetta requires a very specific type of oil in order to keep the engine properly lubricated, as well as performing at its most efficient. When you seek out some replacement oil, you should look for 5W30 Motor Oil. This synthetic oil is designed to withstand the heat from the engine more than conventional oil.
How many quarts of oil does a 2013 Jetta take?
6.3 quarts
Engine Oil Make sure the oil meets the Audi, Volkswagen oil quality standards listed. Capacity: 6.3 quarts (with filter)Add 0.5L (0.5 qt) less than capacity shown, start engine,let run until operating temperature is approx.
How much oil is in a VW Jetta?
Mara D. January 2, 2020 The 2013 Volkswagen Jetta 2.0L motor oil capacity is 4.9 US quarts (4.6 liters). The motor oil capacity for the 1.4L engine is 4.2 US quarts (3.9 liters) and 6.3 US quarts (5.9 liters) for the 2.5L engine. The SAE 5W-30 or 5W-40 engine oil is recommended for all operating temperatures for the 2013 Volkswagen Jetta.
How often should you change the drain plug on a VW Jetta?
Spin out the oil drain bolt and allow the old oil to drain out for at least a few minutes or until the flow slows to an occasional drip. Volkswagen recommends replacing the oil drain bolt at every oil change. Some people prefer to replace the drain plug every other oil change or every third oil change.
Where is the oil drain on a VW Jetta?
Slide under the front passenger side of the engine bay with a Torx T25 screwdriver, a 19mm socket, a 3/8″ drive ratcheting wrench, the used oil catch container and a small flathead screwdriver. The silver metal oil drain bolt is located at the rear edge of the black metal oil pan towards the back of the engine bay.
How to change the oil in a VW Beetle?
Find Oil Drain – Locate the oil drain plug underneath the vehicle 4. Drain Oil – Set up the workspace, drain oil and replace plug 5. Find Oil Filter – Locate the oil filter 6. Remove Filter – Position drain pan and remove the oil filter 7. Replace Filter – Add oil to the new oil filter and insert it 8.