Where is the ABS warning light on a VW Jetta?
See all problems of the 2014 Volkswagen Jetta . The contact’s son owns a 2012 Volkswagen Jetta. The contact stated that at start-up the abs warning light illuminated. The vehicle was taken to ancira Volkswagen in san antonio located at 6125 bandera rd, san antonio, TX 78238, to be diagnosed.
Where is the ABS module on a 2009 Volkswagen Jetta?
Unless I pay $1500 dollars for a new ABS module. I don’t believe this honest or integrity for the customer. When u purchase a 2009 Volkswagen Jetta. As a customer, you can’t see the Abs module, it’s hidden under cover on passenger side under hood.
Is there a problem with my VW Jetta?
See all problems of the 2009 Volkswagen Jetta . If I drive with the car the brake-warning light, abs light and airbag light turns on. It alarms. I brought it to dealer and they asked germany but they couldn’t figure out what wrong is. I am afraid to drive with these lights. They reset the computer but it happens after 20 miles again.
What does it mean when the ABS light comes on?
The ABS module needs to be restore or replace. The lights on the dashboard that comes on includes engine, brakes, steering, ABS, and E.T.C. (electronic throttle control). What actually happens when it comes on is it hard to steer, acceleration goes slow, beeping hearing test noise frequents, gas gauge goes to E, and speedometer stops working.
Where to get ABS replaced on Volkswagen Jetta?
The vehicle was taken to ancira Volkswagen in san antonio located at 6125 bandera rd, san antonio, TX 78238, to be diagnosed. The contact’s son was informed that the abs control module needed to be replaced. The vehicle was not repaired.
When does the ABS light turn on in a VW?
Under normal operation, the Volkswagen ABS light turns on when you first turn on the ignition but turns off within five seconds after the engine starts. When the system functions properly and no faulty codes are detected by the ABS control module, the ABS light stays off.
How to erase ABS light trouble codes on a VW?
Loosen the retaining nut on the cable that runs to the VW’s negative battery terminal. Slide the cable clamp off the negative battery terminal. Wait one to two minutes. This will reset the ECU and begin the process of erasing the trouble codes.
When do the ABS brake and traction control lights come on?
Those three lights all come on when there is a fault in the ABS or Traction system. They all light up to basically grab the drivers attention as it is a safety concern because with those lights on, ABS and traction control are no longer in working order and can cause an accident.
How does the ABS work on a Jetta?
In most cases, if there are faults in both of these modules, and all of these lights come on at the same time, then there is a fault within the steering column itself. There is an item called a clock spring that 1) sends signals to the driver’s side airbag and 2) sends steering angle information to the ABS/traction computer.
Do you need an airbag reset on a VW Jetta?
If your airbags have deployed you will need to get a VW Jetta Airbag light reset or repair service. You want to make sure your airbags, seatbelts, and all other parts of your VW Jettas SRS will work properly if an accident occurs. A dealer is likely to tell you that you need to get a new airbag module, which can cost you upwards of $1,000 dollars.
When does the ABS warning light come on?
Anytime a problem occurs in the ABS brake system the warning light gets on. In fact, ABS light stays on unless you fix the core issue. Basically, the warning light alerts the driver that the safety system is no longer active.
How does the VSS work on a VW Jetta?
The VSS is one part of a system of sensors that helps keep you safe (traction control, ABS, cruise control). A modern vehicle’s speedometer takes the input from the Vehicle Speed Sensor and sends that data to the ECU. The ECU is programmed with your Jetta’s gear ratios and stock tire height.