How do you reset the service light on a 2008 Volkswagen Passat?
Oil Change Light Reset Volkswagen Passat 2006 2007 2008 Procedure
- Use rocker switch on the wiper lever to select “SETTINGS”.
- Confirm with button underneath wiper lever.
- Select “SERVICE” and then “RESET” and confirm.
- Turn the ignition off. or Turn the ignition to the “RUN” position.
How do you reset the service light on a 2006 Volkswagen Passat?
Press and hold TRIP button on the wipers stalk (right side of the steering wheel). Use the TRIP buttons to navigate and OK/Reset button to cinfirm. Go to SETUP → Service interval → Reset and confirm the reset procedure. Turn the ignition off.
How do you clear the code on a VW Passat?
How to Reset a Volkswagen Check Engine Light
- Connect the diagnostic code scanner to the vehicle’s diagnostic port.
- Turn the key to the “Run” position, but do not start the engine.
- Press the button on the scanner that reads “Scan for trouble codes.”
- Wait for the scanner to finish scanning the engine’s computer.
How do I reset my AdBlue sensor?
Mercedes Adblue Reset
- Turn ignition on once.
- Press and hold the gas pedal. Keep the gas pedal pressed until the glow plug comes back on.
- Wait for the glow plug light to stop blinking. Then turn off the ignition.
- Wait 10 seconds with the ignition off.
- Turn the ignition back on.
- Press the gas pedal two times.
How do you reset service interval on a VW Passat?
1) Hold down the wrench button (right hand of the trip reset button). 2) While holding the wrench button, turn on the ignition. 3) The computer will now show something like: ‘Service Now’. 4) Release the wrench button. 5) Now, press and release the the min (right hand of the h button). 6) Turn off the ignition.
Where is the service light on a Volkswagen Passat?
Turn the ignition key to the “key-on/engine-off” position to turn on all the power options for the Passat without actually starting the engine. At this point, a service indicator light will display (in the form of a wrench).
How do you reset the Spanner light on a Volkswagen Passat?
After turning the Ignition, the spanner light will display ( the spanner light must steady and not blinking). Now release the 0.0/SET button and press the button on the left side of the instrument cluster. After you press the button, the spanner light will reset and disappear.
How do you reset the odometer on a Passat?
At this point, a service indicator light will display (in the form of a wrench). Press the minute adjustment button on the clock (or turn the knob clockwise on European manufactured Passats) and release the trip/odometer button. On 2007 and newer Passats, there are some that have a “wrench button” to the right side of the trip reset.